LS10144-001SK-E
annunciator or a 5860, 6860 & 6855 remote annunciator.
Note: Mapping cannot be programmed through the on-board and remote annunciators. Mapping is only avail-
able through HFSS Honeywell Fire Software Suite up/downloading software.
The following subsections describe programming basics, including a description of editing keys available for
programming and how to move through programming menus. Section 9 contains specific information about
individual programming options.
8.4.1
Entering / Exiting the Program Menu
To enter Programming Menu:
1.
Enter the Installer Code (factory programmed default code is 123456).
2.
Then press 7. The menu option displays. See Section 9 for detailed menu information and Section 8.5 for a
quick reference listing all programmable options and JumpStart defaults.
To exit Programming Menu:
When you have completed working with the menus, press left arrow several times until you are exited from
programming mode. Two prompts will display. The first prompt is to make sure you intended to leave the
Program Menu (select Yes or No as appropriate). The second prompt is for accepting all changes. If you select
No, any changes you have made since you entered the Program Menu will have no effect.
8.4.1.1 Moving through the Menus
Figure 8-7 shows how to move through Program Menu screens, using the System Tests screen as an example.
8.4.1.2 Selecting Options and Entering Data
There are several ways to make programming selections using the control panel depending on which screen you
are currently viewing. The chart below is a generic explanation.
To
Enter the number
Enter numeric data
Figure 8-7 Moving through Program Menu
The corresponding number on the annunciator.
The appropriate number on the annunciator.
8-10
Programming Overview
Press