Firstbeat Bodyguard 2 User Manual

FIRSTBEAT BODYGUARD 2 GUIDE

Attachment and utilization of the device

1. Attach the electrodes to
the cable and device end.
Detach the device during showers, sauna and swimming. It is not allowed to wear the device in the water!
Recording continues automatically when you re-attach the device. When you want to end the measurement,
simply detach the monitor from your body and remove the electrodes. The device will stop recording
automatically.
The electrodes are disposable. Change them at least once per day, for example after taking a shower or if they
become loose during the measurement. The glue or electrode paste can irritate your skin, so clean and dry your
skin after removing the electrodes. You can also slightly alter the electrode location between days.
Explanations for signal lights during a measurement
Green led is flashing in sync with the
heart rate.
Green and orange led are flashing
simultaneously.
Red led is flashing or burns constantly.
2. Remove the cover.
Device is recording heartbeat data.
Battery is low, but device is still recording. If you have
just started the measurement, get in touch with your
contact person.
Battery is dead or the memory is full. Recording has
ended. Stop the measurement and get in touch with your
contact person.
3. Attach the device end to
the right side of the body
under the collarbone. The
cable end is attached to the
left side of the body on the
rib cage.
4. The measurement starts
automatically when the
device is attached. Make
sure the green led is
flashing. Note: The light is
easiest to see in a dark
room.