Troubleshooting - Warmlite WL45026 Instruction Manual

TROUBLE SHOOTING
Safety Cut-Out device:
To ensure against the potential hazard
caused by blockage of the air outlet, this
unit is equipped with an automatic over-
temperature safety cut-out device. When the
device is activated the heater will not operate.
If this occurs, the unit can be reset using the
following procedure.
1. Turn the fire off by depressing the On/Off
switch on the unit.
2. Unplug the power cord form the electrical
mains supply socket and leave it
disconnected for at least 10 minutes.
Symptom
The fire won't turn on.
No heat.
Heater operates and
then the heat cuts out.
CUSTOMER SUPPORT TEAM: +44 (0) 333 220 6056
10
Potential cause
Mains plug is not plugged
in.
The On/Off switch hasn't
been switched on.
The fuse in the plug has
blown.
One or both of the heat
selector switches have not
been switched on.
The safety cut-out may
have switched the fire off.
3. Ensure that the air vents are free from
obstruction.
4. Plug the power cord back into the mains
socket.
5. Turn the fire back on.
6. If the fire fails to operate, check the fuse
in the plug.
7. If the fuse in the plug is ok and the fire is
still not functioning, contact a qualified
service person for repair.
Corrective action
Check the mains socket to ensure the
plug has been inserted correctly.
Switch on using the operation switches.
Contact the manufacturer or a qualified
repair service agent for repair.
Ensure that the heat selection switches
have been correctly switched on.
Follow the procedures as outlined in the
"safety cut -out device" section.