Table of Contents
Advertisement
Quick Links
Inventory of content
1. The receiver unit display
2. The remote sensor
3. Instruction Manual
4. Lead Clip
5. Adhesive Hook & Loop
Function:
• Clock
• Ambient temperature
• Fridge temperature
• Min/Max record of temperature
Quick Setup
Note: Use good quality alkaline batteries and avoid rechargeable batteries.
1. Place the batteries into the remote sensor first; then into the receiver
unit.
2.
DO NOT P R E S S A N Y KEY BE FO R E R E C E I V E R U N I T
D I S P L A Y S THE DATA FROM THE REMOTE
ambient and fridge data are displayed you can place your remote sensor on
outside of your fridge and set the current time. Place the sensor wire into your
fridge.
** If the fridge temperature reading is not found on the receiver unit, make sure
the units
are within
installation procedure. If a key is pressed before the receiver unit receives the
fridge temperature signal, you will need to follow the battery installation
procedure again. W AIT 10 SECONDS BEFORE RE -INSERTI NG THE
BATTERIES TO ENSURE A PROPER RESET.
Setting Operation
1. Set Time
Press t h e SET key for 2 seconds, 24H will be displayed. Press + key to
select 24H or 12H time display mode. Press SET key to confirm display mode
selection. If 24H mode selected, temperature will be displayed in degrees
Fahrenheit, if in 12H mode, temperature will be displayed in degrees Celsius.
ENGEL
range of
each other
WIRELESS THERMOMETER
Model: ENGTHERM
Instruction Manual
SENSOR. After both
or
repeat
the
battery
Advertisement
Table of Contents
Summary of Contents for Engel ENGTHERM
- Page 1 Inventory of content ENGEL WIRELESS THERMOMETER 1. The receiver unit display Model: ENGTHERM 2. The remote sensor Instruction Manual 3. Instruction Manual 4. Lead Clip 5. Adhesive Hook & Loop Function: • Clock • Ambient temperature • Fridge temperature • Min/Max record of temperature Quick Setup Note: Use good quality alkaline batteries and avoid rechargeable batteries.
- Page 2 After selecting the time display mode, the sensor unit will update to the correct degree reading automatically: Now the hour digits is flashing, press + key briefly to increment hour, if + key is pressed longer than 2 seconds, then hour digit will be incremented automatically in 4HZ speed.
Need help?
Do you have a question about the ENGTHERM and is the answer not in the manual?
Questions and answers