Blendtec STEALTH 895 Owner's Manual And User's Manual page 50

• Error: Touch controller output is invalid
CONNOISSEUR 825™
Overtemp Error — This indicates that the motor is overheating� The blender
has been disabled until the unit cools to operating temperatures� If the
blender does not work after 20 minutes or more of cooling time, please
call your Blendtec Service Agent�
Overload Error — This indicates an overload on the motor�
1� Clear the error message by pressing any button or turning the blender off and
on again�
2� Remove the jar, and run the blender to determine whether the issue relates to
the jar or the motor�
3� With the jar removed, check for blockage in or around the socket on the motor
base and the blade assembly on the jar�
4� Place the jar securely on the motor base, and touch to pulse the blade through
the mixture�
5� Ensure the jar is not loaded with excessively hard or thick ingredients�
If overload condition re-occurs, contact your Blendtec service agent�
A "Watchdog Timeout" error indicates a disruption in the normal operation of
the electronic blender controls� This is an uncommon error message, which is
usually caused by incoming power fluctuations or spikes� This error message is
cleared by turning off the blender for 10 seconds (using the switch), then turning
back on� If this error is displayed immediately on start-up, or if it occurs regularly
during normal use contact your Blendtec service center for assistance�
CHEF 775™
Overtemp Error — This indicates that the motor is overheating� The blender has been
disabled until the unit cools to operating temperatures� If the icon does not disappear
after 20 minutes or more of cooling time, please call your Blendtec Service Agent�
Touch Error — This indicates that more than one touch sensor on the blender has
been touched� To avoid this message, touch the center of the desired button�
If this icon remains on when no one is touching the touch area, unplug and re-plug
in the blender� If the problem persists please contact your Blendtec Service Agent�
Overload Error — This indicates an overload on the motor�
1� Clear the error message by pressing any button or turning the blender off and
on again�
2� Remove the jar, and run the blender to determine whether the issue relates to
the jar or the motor�
3� With the jar removed, check for blockage in or around the socket on the motor
base and the blade assembly on the jar�
4� Place the jar securely on the motor base, and touch to pulse the blade through
the mixture�
5� Ensure the jar is not loaded with excessively hard or thick ingredients�
If overload condition re-occurs, contact your Blendtec service agent�
Reset Errors — If this message appears on the LED information center it indicates
48