Taser AXON FLEX Quick Start Manual

TASER AXON flex Quick Start Guide
English (U.S./Canada/Australia/U.K.)
Hardware
AXON flex Camera
AXON flex Controller
Step 1:
Recording
The AXON flex system has two operating modes. The default mode, or BUFFERING
mode, provides pre-event buffering to capture activities that occur before you
activate the EVENT (recording) mode.
1 Turn the system on. Move the ON/OFF switch to the ON position.
• The camera takes a few seconds to boot up and be ready to record (the red area
under the switch will be exposed with the switch moved to the ON position).
• The operation LED will be solid red and then transition to blinking green
when the system goes into BUFFERING mode.
• The system will go into BUFFERING mode after the boot up sequence. The
BUFFERING mode holds the previous 30 seconds of video [NO AUDIO] leading
up to the beginning of a recording.
Step 2:
Controller Operation LED
The controller's operation LED displays the system's current operating mode.
Operating Mode
Recording
Buffering
Booting up/powering down
Disconnect
Straight or Coiled Cable
with Right-Angle Connector
Solid Red Blinking Green
Boot Up Mode Buffering Mode
Controller LED
Blinking red
Blinking green
Solid red
Blinking yellow

Quick Reference

Volume/Pairing Button
Battery LED
Green = 41% - 100%
Yellow = 20% - 40%
Red = Less Than 20%
2 To record, quickly double-press the EVENT button.
• The system now records audio as well as video.
• The system will beep twice to let you know that recording started. The 2
beeps will repeat every 2 minutes (if the system is muted, there will be no
audio notifications).
• The operation LED will blink red.
Event Button
3 To stop recording and return to BUFFERING mode, press and hold the EVENT
button for at least 3 seconds until there is a long, audible beep.
Because the system does not capture audio in BUFFERING mode, the first 30
seconds of a recorded event will be video-only (depending on your agency's
settings). BUFFERING mode starts only after the camera is turned on. The system
does not record when the AXON flex controller is turned off.
Step 3:
Controller Battery LED
The controller's battery LED displays the battery's remaining capacity, when the
device is being used or when charging.
Battery Capacity
Battery capacity is 41-100 percent
Battery capacity is 20 - 40 percent
Battery capacity is less than 20 percent
Battery critically low
AXON flex
Operation LED (On Back)
Power Switch
Red = On/Buffering
Event Button
Double Tap = Start Record
Hold 3 Sec = Stop Record
Battery Status Button
Push to Show Status of
Battery
Blinking Red - Record Mode
Battery LED
Green
Yellow
Red during operation; flashing red and
yellow during charging
Blinking red and yellow