Top Cover Assy (Pl1.1.20) Removal - Epson AcuLaser C8500 Service Manual

Color laser page printer

Hide thumbs Also See for AcuLaser C8500:

Table of Contents

EPSON AcuLaser C8500

3.2.5.4 TOP COVER ASSY (PL1.1.20) Removal

1. Open the FRONT COVER ASSY.

2. Open the EXIT UPPER ASSY.

NOTE: In the following step, the TOP COVER ASSY is kept connected to the

printer body with a harness. Therefore, do not move the TOP COVER

ASSY too far from the printer.

3. Remove 4 screws (silver, cup head, 8mm) securing the TOP COVER

ASSY. Then, lift up the rear end of the TOP COVER ASSY, bring the

assembly to the front rotating it clockwise while supporting it by its front left

part, and separate the assembly from the printer body.

4. Remove the OPERATION PANEL from the TOP COVER ASSY. (See

Section 3.2.5.12.)

When installing the TOP COVER ASSY, be sure to fasten the

2 screws at the back to secure TOP COVER ASSY and REAR

COVER ASSY together. Pay a special attention to the left

screw. Fasten it while pressing down the TOP COVER ASSY

securely so that the rib in the TOP COVER presses the TOP

COVER SWITCH without a fail.

Disassembly/Assembly/Adjustment

Disassembly/Assembly Procedures

Figure 3-6. TOP COVER ASSY Removal