Assembly And Setup; Safe Handling Guidelines - GE T2100-ST1 Operator's Manual

Assembly and Setup

3
The T2100-ST1 and T2100-ST2 treadmills are shipped fully
assembled and packaged in a knock down condition. They are
designed to pass through a standard 36" door opening measuring
at least 35½". It will be necessary to remove the door from the jamb
in most cases if the door is not capable of opening fully parallel to
door opening. After you have unpacked the treadmill and secured
the handrail assembly to the frame, move the treadmill to the area
by rolling it on its front wheels. If your treadmill must pass through a
door opening less than 36" wide, additional disassembly will be
required. This task should be performed by an authorized service
provider to ensure that the T2100-ST1 and T2100-ST2 are properly
reassembled and functioning correctly.

Safe Handling Guidelines

 Do not attempt to move the treadmill with the handrails in the
 Lift the end of the bed assembly to a comfortable height,
 Rotate the treadmill in the direction you want to go (the
 When you have maneuvered the treadmill into its location,
2097937-001 Rev E
12 June 2017
shipping position due to the possibility of cutting the internal
wiring. You must either fully secure the handrails in their proper
position or secure handrails with 3/8-16 bolt in the folded
position.
keeping knees bent and back straight as you lift.
treadmill will pivot on its wheels) and push forward.
gently lower the end of the bed assembly to the floor.
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
3
27