Advertisement
Quick Links
Step 1 – Install batteries
From the FRONT of the battery holder unscrew 4 screws to remove
battery cover. Install 3 fresh AA batteries, observing the correct
polarity (+/-). Replace battery cover and tighten the screws.
Do not mix old and new batteries and do not mix alkaline, standard
(carbon-zinc) or rechargeable (ni-cad, ni-mh, etc.) batteries.
Step 3 – Positioning
of larger bracket
Attach larger bracket onto
battery holder by inserting the
2 screws into the 2 screw slots:
Do not tighten yet! Position as
shown in photo.
Insert
Screw
Larger
Bracket
Small
Small
Bracket
Bracket
Wheel Brightz
Installation Instructions
© Copyright Brightz, Ltd. 2014
Batteries
Step 4 – Tightening of
larger bracket
Next, slide bracket toward the
center of the wheel until the
battery holder fits snugly. THEN
tighten the 2 screws. Verify that
the battery holder is firmly
attached to the spokes.
Larger
Bracket
Pull
Up
Small
Small
Bracket
Bracket
All rights reserved
Step 2 – Remove larger bracket
Gently lay bicycle on the ground. (It's easier to install Wheel
Brightz with the bicycle lying on its side.) Unscrew 2 screws from
the larger bracket on the back of the battery holder. Remove the
larger bracket and set aside. Insert the battery holder facing
inward and slide the battery holder away from the center hub
until the spokes fit snugly in the smaller bracket. (For rear wheels
do not mount on the side where the chain is located.)
Larger
Bracket
Small
Bracket
Step 5 – Insert the tube LED lights
Insert the clear tubing with the LED lights into the "hollow" area
of the wheel.
Wheel
Hub
Spokes
Pull
Down
Advertisement
Related Manuals for Brightz Wheel Brightz
Summary of Contents for Brightz Wheel Brightz
-
Page 1: Installation Instructions
Gently lay bicycle on the ground. (It’s easier to install Wheel From the FRONT of the battery holder unscrew 4 screws to remove Brightz with the bicycle lying on its side.) Unscrew 2 screws from battery cover. Install 3 fresh AA batteries, observing the correct the larger bracket on the back of the battery holder. - Page 2 Step 6 – Place connector Step 7 – Push clear tube to rim Place the connector next to the base of a spoke. Push the clear tube to the rim of the wheel. Starting at the connector Connector does not snap in. continue all the way around the rim until you reach back to the connector.
Need help?
Do you have a question about the Wheel Brightz and is the answer not in the manual?
Questions and answers
installed on a bike i bought used .. how do you turn it on and off?
To turn on the Brightz Wheel Brightz, press the power button once. To turn it off, press the button again. The lights cycle through colors automatically, and pressing the button stops the cycle at the current color.
This answer is automatically generated