Related Manuals for Extech Instruments SDL800
Summary of Contents for Extech Instruments SDL800
- Page 1 User's Guide Vibration Meter SD Card real-time datalogger Model SDL800...
-
Page 2: Meter Description
Introduction Congratulations on your purchase of the Extech SDL800 Vibration Meter. This meter displays and stores vibration readings of Acceleration, Velocity and Displacement. Supported measurement units are meters/s , ft/s , g, mm/s, cm/s, in/s, mm and inch. Logged data readings are stored on an SD card for transfer to a PC. -
Page 3: Getting Started
UNIT button. The meter begins scrolling through the available units of measure after the UNIT button has been depressed for at least 1.5 seconds. The saved units will become the default turn-on units. UNIT DISPLAY INDICATOR mm/s cm/s DISP p-p ft/s In/s DISP p-p inch SDL800-EU-EN-V1.2-11/11... - Page 4 To exit the MAX-MIN mode, press and hold the MAX-MIN button for at least 1.5 seconds. The meter will beep, the REC-MAX-MIN icons will switch off, the MAX-MIN memory will clear, and the meter will return to the normal operating mode. SDL800-EU-EN-V1.2-11/11...
-
Page 5: Setup Mode
4. Press the ENTER button to confirm the entry. 5. Press and hold the SET button for at least 1.5 seconds to exit to the normal operation mode (or simply wait 7 seconds for the meter to automatically switch to the normal operating mode). SDL800-EU-EN-V1.2-11/11... - Page 6 After pressing the Reset button, switch the instrument ON by pressing and holding the POWER key for at least 1.5 seconds. If using the power adaptor unplug the adaptor and then plug it back in again to power the meter. SDL800-EU-EN-V1.2-11/11...
-
Page 7: Data Logging
4. Use the ▲ and ▼ buttons to select one of the 99 data memory positions in which to record. 5. To exit the manual datalogging mode, press and hold the LOG button for at least 1.5 seconds. The DATALOGGER icon will switch off. SDL800-EU-EN-V1.2-11/11... - Page 8 Plug the SD Card directly into a PC SD card reader. If the PC does not have an SD card slot, use an SD card adaptor (available at most outlets where computer accessories are sold). Power the PC and run a spreadsheet software program. Open the saved documents in the spreadsheet software program (see example spreadsheet data screen below). SDL800-EU-EN-V1.2-11/11...
-
Page 9: Battery Replacement And Disposal
Replace the battery compartment cover with the two (2) Phillips screws. All EU users are legally bound by the battery ordinance to return all used batteries to collection points in your community or wherever batteries / accumulators are sold! Disposal in the household garbage is prohibited! SDL800-EU-EN-V1.2-11/11... -
Page 10: Specifications
Above specification tests under the environment RF Field Strength less than 3 V/M & frequency less than 30 MHz only and 23±0.5 Copyright © 2011 Extech Instruments Corporation (a FLIR company) All rights reserved including the right of reproduction in whole or in part in any form www.extech.com...
Need help?
Do you have a question about the SDL800 and is the answer not in the manual?
Questions and answers