iHome iBT61 User Manual page 2

Bluetooth Mode
Switch
Speaker ON
Press and hold to pair
2 Sec
Press to play and pause audio
Speakerphone Mode
Press to answer and end calls
Speaker front view
Microphone
Speaker back view
End/Answer Call/
Play/Pause/
Bluetooth Pairing
Button
Rubber Pad
Note: Clean rubber pad
on bottom of speaker
with damp cloth
for best performance
Charging cable
Computer
connected to
working outlet
Speaker back view
USB Charging Jack
LED
Off/On
Switch
Charging the iBT61
CHARGE BEFORE USE
charging cable included
Computer USB port
USB AC adaptor
(not included)
USB AC adaptor
connected to working outlet
Locking and Unlocking the iBT61
To compress and lock speaker, gently press speaker down from the top and
twist clockwise to lock in place.
To unlock and expand the speaker, grip the top and bottom and give a small
twist counter-clockwise. DO NOT pull hard once open, as the built in spring will
automatically extend the speaker to its proper position.
Charging the iBT61
The iBT61 is powered by a rechargeable battery in the speaker. Make sure to
charge speaker before use.
• Connect the micro-USB plug on the included charging cable to the
Charging jack on the speaker.
• Connect the larger USB plug to a powered USB port, such as that on a
computer. Your computer should be connected to a wall outlet when speaker
is charging. The light on the speaker will turn to solid red while charging and
turn off when fully charged.
• If the LED flashes red, or you notice sound distortion at higher volumes, or
there is no sound at all it's time to recharge the battery.
Using Bluetooth with the iBT61
• Slide the Off/On Switch on the speaker to the on position.
• Press and hold the Bluetooth Pairing Button for 2 seconds.The LED
will flash blue and red, a tone will sound as the speaker attempts to pair with
a Bluetooth device.
• Place your audio device in Bluetooth mode (often found in the device's
Settings or Tools menu) and make it "discoverable". "iHome iBT72Y" should
appear on your device's Bluetooth menu. Select it to connect. If your device
asks for a passcode, enter '1234'.
• Once paired, the light will glow solid blue and a confirmation tone will sound.
You can then stream audio to the speaker. If pairing is not successful, turn the
power off on the speaker and repeat pairing procedure.
• To listen to Bluetooth audio, make sure the
on position. Press the Play/Pause Button to cycle between play and
pause modes.
• Control audio volume and track navigation from your device.
Remember to turn off the speaker and your device after listening.
NOTE: When unit is charging, the blue light will appear solid red.
Using the iBT61 Speakerphone Mode
The speaker must be on and connected to a paired Bluetooth phone to receive
calls. When a call comes in, any playing audio is paused, the LED will flash
blue 2X and the ringtone associated with the caller may sound, depending on
Bluetooth device.
• Press the End/Answer Call Button to answer the call. Press again to
end the call.
USB
Switch on the speaker is in