Set Snmp Trap Auth; Set System Contact; Set System Location - Avaya X330W2-DS1 User Manual

Output Example:
To add an entry in the SNMP trap receiver table with default:
X330WAN-2DS1-1(super)# set snmp trap 192.168.173.42
SNMP trap receiver added.

set snmp trap auth

Use the set snmp trap auth commands to enable/disable the sending of
SNMP traps upon SNMP authentication failure.
The syntax for this command is:
set snmp trap {enable|disable} auth
Output Example:
X330WAN-2DS1-1(super)# set snmp trap enable auth
Authentication trap enabled

set system contact

Use the set system contact command to set mib2 system contact MIB
variable.
The syntax for this command is:
set system contact [contact string]
contact string
Example:
set system contact "Gabby ext.545"

set system location

Use the set system location command to set the mib2 system location MIB
variable.
Avaya X330W-2DS1 User's Guide
Contact person. The contact person field is cleared if this field is
blank. A string of 2 words or more must be type in quotation
marks – e.g. "Yigdal Naouri".
General: Device Commands
55