Ebac CD35 User Manual

IF YOUR DEHUMIDIFIER FAILS TO
OPERATE
1. Check that the plug is fully pushed into the
socket and is switched on.
2. Check with some other electrical device that
the wall socket is "live". If it is not, contact a
qualified electrician.
3. Check the fuse in the plug. If you replace the
fuse, refit with a 13Amp fuse.
4. Check the humidistat control is turned
clockwise.
5. Check that the water container is not full.
Should none of the above remedies work, then
disconnect from the mains. Contact the help line on
01388 605061. DO NOT attempt to repair the unit
or unscrew the outer casing.
ELECTRICAL CONNECTION
If the appliance is fitted with a plug for which your
socket is unsuitable, then it should be cut off and
an appropriate plug fitted..
This appliance complies with the suppression
requirements of the EEC direction 82/199/EEC as
embodied in BS800:1988.
IMPORTANT:- The wires in this mains lead are
coloured in accordance with the following code:-
Green & Yellow Earth
Blue Neutral
Brown Live
WARNING – THIS APPLIANCE MUST BE EARTHED
TECHNICAL SPECIFICATIONS
Min Operating Temperature
Max Operating Temperature
Water Extraction (24hrs) 32°C / 90%RH
Max Power Consumption 32°C / 90%RH
Max Running Current
Fuse Rating (UK)
•
Do not remove the front or rear panels
•
This machine should be serviced by qualified Ebac personnel or other persons having technical
competence servicing refrigeration equipment following the instructions in the Ebac service manual.
•
Ebac service manuals and spares lists are available upon request by contacting your local Ebac
distributor.
•
Never operate the unit in a bathroom or swimming pool area
•
Do not use the machine if the power cord or cabinet are damaged.
•
Do not poke objects into and of the grilles on the machine.
•
Do not cover or obstruct the air inlet or outlet.
•
When running, the noise level of this machine is less than 70dba
•
This machine complies with the electromagnetic compatibility 1992 regulations.
• This machine has been manufactured in the United Kingdom.
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your own plug,
proceed as follows:
The wire which is coloured Green and Yellow must
be connected to the terminal in the plug which is
marked with the letter E or by the Earth Symbol or
coloured Green and Yellow. The wire which is
coloured Blue must be connected to the terminal in
the plug which is marked with the letter N or
coloured Black. The wire which is coloured Brown
must be connected to the terminal which is marked
with the letter L or coloured Red.
You must dispose of the non rewireable plug once it
has been removed from the flexible cord. It is
dangerous to attempt to insert the plug into any
electrical socket elsewhere in the house. If the
flexible cord becomes damaged it must be replaced
by an identical cord.
CHANGING THE FUSE
Only 13 Amp fuses that are ASTA approved to
BS1362 should be used.
The fuse cover must be refitted after replacement
of the fuse. In the event of the fuse cover being lost
or damaged, the plug must not be used until a
replacement is obtained. Replacement fuse covers,
which must be coloured BLACK, are obtainable
from electrical retailers.
CD35 230V/50Hz/1 Phase
Height 540 mm
Width 355 mm
Depth 380 mm
Weight 22 kg
1 °C
35 °C
11,5 l
350 W
1,9 A
13 A
Pump Capacity 3,2 l
HEAVY DUTY
CD35
DEHUMIDIFIER
USER MANUAL
TP - 204