Audio Level
~
~
~
O utput Level
Frequency
Control
Control
Wheel (K)
Wheel
(N)
STEP 2
SET THE TRANSMITTER "LEVEL"
1. Set the Frequency Control Wheel (N) to its midpoint.
2. Turn the Output Level Control wheel (K) all the way to
the right as shown.
3. Check status of Audio Level Indicator Light (H). If it
flickers intermittently (about half the time), proceed to
"Tune the Speakers".
4. If Audio Level Indicator Light is on solid red or flickering
very rapidly, turn wheel slowly back to the left until light
flickers intermittently.
Note: If the light does not flicker, confirm secure connection
of the AC adapter. If the light still does not flicker,
confirm secure connection
to
the audio source output.
If there is still no response, leave the Output Level
Control Wheel completely
to
the right (as shown) and proceed.
Hint: If the transmitter is connected
to
a variable output (i.e. Headphone Jack, TV audio
out) on the audio source, leave the Output Level Control Wheel turned all the way
to
the right (as shown) and adjust the volume on the audio source up or down as
necessary
to
make the Audio Level Indicator Light (H) flicker intermittently.
lJlM IH£
SPEAKERS
Adjust the speakers as follows:
TURN ON AND TUNE THE SPEAKERS
1. Use the speaker Power ON-OFFNolume Control Wheel (0)
to turn the speaker "ON." Tuning Indicator Light (A) will
illuminate red.
2. Turn the Tuning Control Wheel (B) until the audio source
is heard. The Tuning Indicator Light (A) will change
color to green, indicating the speaker is tuned to the
signal from the transmitter.
3. Adjust volume as desired.
4. Set the Left/Mono/Right Switch (C) accordingly (see
"Setting the Speakers for Stereo/Monaural
Operation" on page 9).
5. Repeat process for other speaker.
Note: Interference in the form of static and/or
distortion can sometimes be heard. If this
occurs, confirm correct transmitter/speaker adjustments and
indicators. If the problem persists, refer to TROUBLESHOOTING.
8
Tuning Indicator
Light (A)
Power On-OffNolume
Control Wheel (0)
Need help?
Do you have a question about the Advent AW820 and is the answer not in the manual?
Questions and answers