Sanyo MCH-900F Instruction Manual page 7

COMPACT DISC PREPARATIONS
This unit is designed to play compact discs bearing the
identification logo below. Discs that do not carry this logo
may not conform to the CD standard and may not play
properly.
This unit can be used to play 12 cm discs only.
dEiE
DIGITAL AUDIO
Do not attempt to load a 8 cm disc with or without
a snap-on adaptor. Doing so may cause damage to
the disc and CD changer.
Fingerprints and dust should be carefully wiped off the
signal surface of the disc (glossy side) with a soft cloth.
Wipe in a straight motion from the centre to the outside
of the disc.
Never use chemicals such as record cleaning sprays,
antistatic sprays or fluids, benzene or thinner to clean
compact discs.
These chemicals will permanently damage the plastic
surface of the disc.
Always place the compact disc in the disc tray with the
label facing upward. Compact discs can be played on
only one side.
To remove a disc from its storage case, press down on
the centre of the case and lift the disc out. Holding it
carefully by the edges.
Discs should be returned to their cases after use to
protect them to from dust and scratches.
To prevent warping the disc, do not expose it to direct
sunlight, high humidity or high temperatures for ex-
tended periods of time.
Do not apply paper or write anything on either side of
the compact disc. Sharp writing instruments, orthe inks
used in some felt-tip pens, may damage the surface of
the disc.
Important Notes:
1) When positioning the unit for use, be sure to place it on
a flat surface so that it does not tilt.
2) When carrying the unit from one location to an-
other . . .
- When moving the unit a short distance, such as
from room to room, turn the power off and wait at
least 10 seconds for the CD changer mechanism
to reset.
Lift the unit by the handle and be sure to keep the
unit in a horizontal position.
3) When transporting the unit ...
Remove all the discs from the unit.
Carrying the unit around with discs inside can
cause damage to the discs and may cause the
unit to malfunction.
Press the POWER button to turn off the power
and wait at least 10 seconds for the CD changer
mechanism to reset before carrying the unit.
IMPORTANT INFORMATION
Sanyo compact disc changers have built-in error compen-
sation circuits to correct for minor manufacturing defects in
a disc. There are limits, however, to the amount of correc-
tion possible.
In some cases, the CD changer may skip some tracks on
a disc during play. This problem maybe caused by defects
(such as scratches) in the disc being played, which are too
large for the error compensation circuits to handle. If you
encounter this problem, check the operation of the CD
changer as follows, before having the unit serviced.
Play a new disc. If the CD changer operates normally,
the skipping problem is most likely due to a defective
disc.
-6-