Installation; Transceiver Information Mode; Horn Alert/P.a. Relay Unit; Installing The Kap-2 Unit In The Transceiver - Kenwood NX-5800 Service Manual

2.2.9 Transceiver Information Mode

Use this function to confirm the transceiver firmware version, SCM Firmware version and SCM Hardware version.
(1) Enter the Transceiver Information mode by using section "2.2.2 How to Enter Each Mode".
(2) The transceiver firmware version appears on the LCD.
(3) Use the [ ] and [ ] keys to select the confirmation items.
(4) To exit the transceiver information mode, turn the transceiver power OFF.
Note:
When the SCM board is not equipped to the transceiver, SCM Firmware Version and SCM Hardware Version are displayed
as "-.-.-."
2.3

INSTALLATION

ATTENTION:
When installing the option, please take measures to prevent
static electricity.
2.3.1 Ignition Sense Cable (KCT-46: Option)
The KCT-46 is an optional cable for enabling the ignition func-
tion. The ignition function lets you turn the power to the transceiv-
er on and off with the car ignition key.
2.3.1.1 Connecting the KCT-46 cable to the transceiver
(1) Open the KCT-46 fuse holder and insert a mini blade fuse
(3A). <1>
(2) While holding a clear protective cover, remove the black
cap at the end of the yellow cable (ignition sense cable) of
the transceiver. <2>
(3) Connect the plug of the KCT-46 to the yellow cable termi-
nal of the transceiver. <3>
(4) Connect the other end of the KCT-46 to the ignition line of
the car. <4>
Note:
You must setup using the KPG-D1/D1N.
<2>
<3>
F52-0019-05
<1>
2.3.2 Horn Alert/P.A. Relay Unit (KAP-2: Option)
The Horn alert (max. 2A drive), Public address and External
speaker function are enabled by installing the KAP-2 in the trans-
ceiver.
[ ]/[ ]
<4>
Ignition line
of the car
Fig.1
[ ]/[
[ ]/[ ]
2.3.2.1

Installing the KAP-2 unit in the transceiver

(The kit A is not used in the KAP-2 accessories)
(1) Remove the cabinet, top packing and shielding plate of the
transceiver.
(2) Set the KAP-2 relay unit jumper pins according to the pur-
pose of use.
(3) Remove the 6-pin jumper connector inserted in the TXRX
unit (A/2) connector (CN910). <1>
(4) Insert one side of the lead wire with connector (E37-1114-
05) into the relay unit connector (CN3) <2> and the other
side into the TX-RX unit (A/2) connector (CN910) <3>
(5) Place the relay unit at the position shown in Figure 2-2 and
secure it to the chassis with a screw.
]
<1>
CN910
Fig.2-1
E37-1114-05
<2>
CN3
<3>
CN910
Fig.2-2
(No.RA017<Rev.002>)1-11