Sony IPELA PCS-XG80 Installation Manual

Installation Guide

Let's Connect
Notes

Be sure to turn off all the equipment before making any connections.
 Do not connect/disconnect the camera cable, interface cable, or pen tablet with
the power on. Doing so may damage the Camera Unit, Communication System
or ISDN Unit.

For safety, do not connect the 100BASE-TX/10BASE-T connector to a network
that applies excess voltage via the 100BASE-TX/10BASE-T connector.

Used with the Camera Unit or ISDN Unit for the first time, the Communication
System may automatically upgrade the software of the connected equipment.
Upgrade the software according to the message displayed on the monitor
screen. Be sure not to turn off the Communication System or disconnect the
cable during upgrading. Otherwise it may cause a malfunction of the system.
Front
VIDEO IN
YPbPr
Video cable** Audio
cable**
to video
to audio output
output
(YPbPr)
HD player, etc.
© 2008 Sony Corporation
Printed in Japan
PCSA-CXG80 HD Camera
Unit (supplied with the
PCS-XG80)*
to TERMINAL
Camera cable (supplied with
the HD Camera Unit)
EC-MIC(A7)
AUDIO 2 IN TABLET
1/2
Pen tablet**
(Wacom BambooMTE450)
PCSA-A7 Echo Canceling Microphones
(PCSA-A7P4: 4-piece set)**
HD Visual Communication System PCS-XG80/XG80S
3-875-773-14 (1)
TV monitor**
to HDMI IN
HDMI cable*
CAMERA
Rear
MIC(A1/A3)
1(R)/2(L)
S VIDEO
AUDIO 1 IN
IN
Audio cable**
PCS-A1
Microphones S-video cable**
(supplied
with the
PCS-XG80)*
to S-video
or
output
PCSA-A3
Microphones**
VCR, etc.
Connecting two
microphones enables pick-
up of the sound in stereo.
* Supplied
(However, the PCSA-CXG80 HD Camera Unit and the PCS-A1
microphones are not supplied with the PCS-XG80S system.)
** Not supplied
ISDN Unit**
PCSA-B384S**
to TERMINAL
Interface
to ISDN 1 - 3
cable
(supplied
PCSA-B768S**
with the
ISDN Unit)
to ISDN 1 - 6
HDMI OUT ISDN UNIT
ISDN modular cable**
DC 19.5V
RGB IN RGB 1
OUT
AC adaptor*
UTP cable (category 5, straight)**
Connecting cable
with the D-sub 15 pin
connectors**
to audio output
to
RGB
OUT
Computer
Notes
 Normally, connect the UTP cable to the 1 (LAN1) connector (indicated in green). If the UTP cable is
connected to the 2 (LAN2) connector, some of the functions of your system may be restricted.
For details, refer to the Operating Instructions supplied with the system.
 The REC OUT jack is used to make an audio recording of a communication. This is not used during
regular communication.
"IPELA" and
or
ISDN line
Power cord*
to a wall outlet
LAN
Connecting cable with the
D-sub 15 pin connectors**
to RGB IN
Projector, etc.
are trademarks of Sony Corporation.