Configuring A Bridge Group And Assigning Interfaces To A Bridge Domain - Cisco NCS 5500 Series Configuration Manual

Integrated Routing and Bridging
Step 3
end or commit
Example:
RP/0/RP0/CPU0:router(config-if)# end
or
RP/0/RP0/CPU0:router(config-if)# commit
Saves configuration changes.
• When you issue the end command, the system prompts you to commit changes:
Uncommitted changes found, commit them before exiting(yes/no/cancel)?
[cancel]:
• Entering yes saves configuration changes to the running configuration file, exits the configuration session, and
returns the router to EXEC mode.
• Entering no exits the configuration session and returns the router to EXEC mode without committing the configuration
changes.
• Entering cancel leaves the router in the current configuration session without exiting or committing the configuration
changes.
• Use the commit command to save the configuration changes to the running configuration file and remain within
the configuration session.

Configuring a Bridge Group and Assigning Interfaces to a Bridge Domain

To configure a bridge group and assign interfaces to a bridge domain, complete the following steps.
SUMMARY STEPS
1. configure
2. l2vpn
3. bridge group bridge-group-name
4. bridge-domain bridge-domain-name
5. interface [HundredGigE | TenGigE
6. end or commit
DETAILED STEPS
Step 1
configure
Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.1.x
Configuring a Bridge Group and Assigning Interfaces to a Bridge Domain
83