11. Replacing of Pan Sensor and Thermal Fuse 12. Parts Exploded View and Replacement Parts List 12.1 Part Exploded View 12.2 Packing View 12.3 Replacement Parts List : SR-DE103 / SR-DE183 21 - 22 12.4 Replacement Parts List : SR-MS103 / SR-MS183 23 - 24...
SR-DE103, 183 / SR-MS103, 183 1. WARNING WARNING The service information is designed for experienced repair technicians only and is not designed for use by the general public. It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product.
SR-DE103, 183 / SR-MS103, 183 2. SPECIFICATION MODEL SR-DE103 SR-DE183 SR-MS103 SR-MS183 Colour Name White White White White Colour Code Power Supply 110V/60Hz Taiwan Taiwan Taiwan Taiwan 120V/50Hz USA & Canada USA & Canada USA & Canada Panama 220V/50Hz Thailand...
SR-DE103, 183 / SR-MS103, 183 3.2 Block Diagram Lid heater Lid earth lead wire Lid sensor Control board (Power side) Socket Grounding wire Control board (Operating side) Cast heater Side heater - 7 -...
SR-DE103, 183 / SR-MS103, 183 4. TROUBLESHOOTING Before repairing the warm jar from users, please confirm whether it is complete (pan, lid, keep warm pin, etc.) and inquiry the user for specific malfunctions. Please turn off the power before checking the circuit or component.
SR-DE103, 183 / SR-MS103, 183 5. TROUBLESHOOTING-PART I (for the main unit) Note : Mark means the components that may malfunction. Drawing No. 15 23 44 48 48 54 61 6 22 Remark Refer to page 8, when the Malfunctioned malfunctioned parts are Component supposed to be on the...
SR-DE103, 183 / SR-MS103, 183 6. QUICK CHECK TEST FOR THE CONTROL BOARD Check performance of the P.C.B. in the following procedure. If any failure detected, repeat the performance again. (Refer to page 8). If still abnormal, replace spare parts on the control panel or the whole control board (comp.) according to “Troubleshooting-Part II”...
SR-DE103, 183 / SR-MS103, 183 7. TROUBLESHOOTING-PART II (for the P.C.B.) Note : Mark means the components that may malfunction. Drawing No. Remark 38 SW LCD X1 BZ T RL TR1 Parts on the control panel Malfunctioned Component Unit Symptom Description Cooking LED lights up...
SR-DE103, 183 / SR-MS103, 183 8. TEST METHOD 8.1 Bubble test 1. Insert the pan into the cooker main body and turn it slightly clockwise and anti-clockwise to place the pan properly on top of the cast heater. 2. Pour small quantity of water into the pan so that the bottom of the pan is immersed with water. Close the lid completely.
SR-DE103, 183 / SR-MS103, 183 9. REPLACING OF P.C.B. (Comp.) Remove the power socket (comp.) • Open the lid and place the cooker upside down on a rubber sheet to protect it, as shown in the right figure. • Unplug the power cord. •...
Page 15
SR-DE103, 183 / SR-MS103, 183 Remove the body of cooker • Place the cooker upside down on a rubber sheet, then insert the screwdriver upright for about 30 - 40 mm., as shown in the right figure. • Turn the screwdriver in arrow direction to remove the body, as shown in the right figure.
Page 16
SR-DE103, 183 / SR-MS103, 183 Take out the P.C.B. component • Remove the tabs at (a) gently, then take out the P.C.B. (operating side) while lifting. • Remove another fire-retardant tape attached on the bottom of the P.C.B. • Remove the retaining screws gently. Then take out the P.C.B.
SR-DE103, 183 / SR-MS103, 183 10. REPLACING OF CAST HEATER Remove the power socket (comp.) and body • Remove the power socket and body in referring to replacing of P.C.B. base (comp.) Remove the base of sensor • Tear off the retaining tapes (2 places) on the wiring of the pan sensor. •...
SR-DE103, 183 / SR-MS103, 183 11. REPLACING OF PAN SENSOR AND THERMAL FUSE Remove the cast heater • Remove the cast heater in referring to replacing of cast heater. Remove the pan sensor • Upright the tabs (3 places) as shown in the right figure, then take out the pan sensor.
SR-DE103, 183 / SR-MS103, 183 12. PARTS EXPLODED VIEW AND REPLACEMENT PARTS LIST 12.1 Parts Exploded View XTN4+8GFJ XTB4+12GFJ (FOR DE SERIES) (FOR MS SERIES) XYM4+E10FNS XYC4+CF8FJ XTL4+10RTW XTL4+16AVW XTB4+12GFJ XTB4+12GFJ (FOR MS SERIES) (FOR DE SERIES) - 19 -...
SR-DE103, 183 / SR-MS103, 183 Important safety notice : Components identified by mark have special characteristics important for safety. When replacing any of these components, use only manufacturer’s specified part. 12.3 Replacement Parts List : SR-DE103 / SR-DE183 Parts List MODEL COUNTRY / Q’TY REF.
Page 22
SR-DE103, 183 / SR-MS103, 183 Parts List MODEL COUNTRY / Q’TY REF. PART NAME PART NO. SAFETY REMARK SIN- SIN- USA/ DE103 DE183 HK PSV INDO • ARS10U975-0U • ARS10T976-0U • ARS10H976-0U • ARS10U976-0U • ARS10A976-0U • • OUTER SPRING AQS61T2701 •...
Page 23
SR-DE103, 183 / SR-MS103, 183 Screws MODEL COUNTRY / Q’TY REF. PART NAME PART NO. SAFETY REMARK SIN- SIN- USA/ DE103 DE183 HK PSV INDO • • TAPPING SCREW XTB4+12GFJ FIX BODY • • TAPPING SCREW XTB4+12GFJ FIX PCB BASE ASSY •...
SR-DE103, 183 / SR-MS103, 183 12.4 Replacement Parts List : SR-MS103 / SR-MS183 Parts List MODEL COUNTRY / Q’TY REF. PART NAME PART NO. SAFETY REMARK SIN- SIN- USA/ MS103 MS183 • • STEAM VENT ASSY ARC00T975W9U • • OUTER LID ASSY ARB01T975W9U •...
Page 25
SR-DE103, 183 / SR-MS103, 183 Parts List MODEL COUNTRY / Q’TY REF. PART NAME PART NO. SAFETY REMARK SIN- SIN- USA/ MS103 MS183 • NAME PLATE ARY30T975-W9 • ARY30H975-W9 • ARY30V9751W9 • ARY30Y975-W9 • ARY30S975-W9 • ARY30U975-W9 • ARY30A9751W9 • ARY30Z975-W9 •...
Page 26
SR-DE103, 183 / SR-MS103, 183 Screws MODEL COUNTRY / Q’TY REF. PART NAME PART NO. SAFETY REMARK SIN- SIN- USA/ MS103 MS183 • • TAPPING SCREW XTB4+12GFJ FIX BODY • • TAPPING SCREW XTB4+12GFJ FIX PCB BASE ASSY • • SEMS TAPPING SCREW XYC4+CF8FJ FIX EARTH CONNECTION...
Page 27
SR-DE103, 183 / SR-MS103, 183 DETAIL CHANGE NOTICE REVISION ITEM NO. PAGE DETAIL REMARK MAR. 2011 REVISE ADD. REVISION AND ADD. COUNTRIES FOR SALES AS TW, DESTINATION USA/CND, PANAMA AND AU/NZ REVISE SPEC. ADD. DATA OF NEW COUNTRIES CUTTING INLET CASE BUT ADD. REVISE PARTS TO USE ASSEMBLY FOOT RUBBER IN EXPLODE VIEW NO.
Need help?
Do you have a question about the SR-DE183 and is the answer not in the manual?
Questions and answers