Setup Parameters Easygen-3000 Series - Woodward RP-3000 Manual

Configure CAN Interface > Connection CAN Interface 2... > Setup Parameters easYgen-3...
4.2.1.2

Setup Parameters easYgen-3000 Series

4.2.1.2.1 Front Panel Access
Baudrate
Node-IDs
37534C
The easYgen can be configured using the following access
methods:
External access with a PC (easYgen-3000 Series) using the
n
ToolKit configuration software.
Ä Chapter 4.2.1.2.2 "Access Via PC (ToolKit)" on page 47
Access via the front panel (easYgen-3200/3500 only)
n
Ä Chapter 4.2.1.2.1 "Front Panel Access" on page 45
The following chapter decribes the configuration via
the front panel (easYgen-3200/3500 only).
"Parameter è Configuration è Configure interfaces
1. Select
Configure CAN interface è Configure CAN interface 2" .
è
2. Set the "Baudrate" to "250 kBd".
Baudrate
CANopen interface
J1939 interface
Table 12: Configure CAN interface 2 screen
"Parameter è Configuration è Configure interfaces
1. Select
Configure CAN interface è Configure CAN interface 2
è
CANopen interface" .
è
2. Please make sure that the parameter "This device" is config‐
ured to "Node-ID 7" (Refer to
1/3" Table on page 45 for details).
3. Please make sure that the parameter "RP-3000" is config‐
ured to "Node-ID 6" (Refer to
2/3" Table on page 46 for details).
4. Set "Configure external devices" to "Yes" (Refer to
open interface screen 3/3" Table on page 46 for details).
ð The settings will be transfered to the
easYgen-3200/3500.
This device
IKD1 DI/DO 1..8
IKD2 DI/DO 9..16
IKD3 DI/DO 17..24
RP-3000 | Remote Panel
Configuration
250 kBd
->
->
Ä "CANopen interface screen
Ä "CANopen interface screen
Ä "CAN‐
Node-ID 7
Off
Off
Off
45