Draytek VigorAP 910C Quick Start Manual page 6

3 . 2 C e i l i n g - m
3 . 2 C e i l i n g - m
1. Place the bracket under the wooden ceiling and fasten two turnbuckles firmly
(as shown in Figure below, Step 1).
2. Make the screws pass through the bracket and insert into the turnbuckles (as
shown in Figure below, Step 2). Fasten them to offer more powerful
supporting force.
3. When the bracket is in place, fasten two screws firmly (as shown in Figure
below, Step 3) on the bottom of VigorAP.
4. Make the device just below the bracket. Put the screws installed in Step 3 on
the screw holes of the bracket (as shown in Figure below, Step 4).
5. Gently rotate the device to make screws slide into the notches of the bracket
and move forward till it is firmly fixed.
o u n t I n s t a l
o u n t I n s t a l
Step 1
l a t i o n ( C e m e
l a t i o n ( C e m e
Step 4
n t o r H a r d C
n t o r H a r d C
Bracket
Step 2
Step 3
e i l i n g s )
e i l i n g s )