Advertisement
Quick Links
Advertisement
Summary of Contents for Ciel EaM Batz 2.0
- Page 1 (CE10504) ciel EaM Manual V4.0.0.E...
- Page 2 Thank you very much for buying a ciel EaM bat detector. Warning notes: - A bat detector is not a toy - Danger of choking ! Small parts. Not suitable for children under 3 years! - Loud noises, especially on headphones, may damage your ears ! - Never use the detector with headphones near any hazardous places (traffic etc.), as you might not be aware of any upcoming danger.
- Page 4 Functions of the detector: A Microphone – The electret microphone is very sensitive to ultrasonic calls, it is mechanically robust and water resistant but not waterproof. To prevent the microphone from being damaged avoid direct contact to water or any other fluids. B Display –...
- Page 5 General information about your detector: The heterodyne detector (HD): A heterodyne detector works similar to a broadcast receiver. The frequency you have chosen will be subtracted from the bat call with a bandwidth of +/- 5 kHz transforming it to the audible range. As an example : Detector is set to 42 kHz Call frequency Setting...
- Page 6 First steps: Open the battery case on the rear side and place a 9 volt battery in the compartment. Please pay attention to the polarity of the battery. To turn the detector on press the On/Off button (D) until the display (B) shows '----'.
- Page 7 atmospheric absorption will occur. High humidity will also raise the absorption level. Recording/Playback of a call: Push the button Rec (E) in HD mode to record a call. The recording will start immediately and the memory LED on the upper left side of the display will begin to flash.
- Page 8 Fax +49 5353 90 30 555 E-mail info@eam-walter.de Warranty is 24 months after purchase at Ciel EaM or any of its licensed distributors (see list at www.eam-walter.de). Please keep your invoice as this is also your warranty document. You will need to submit this document with any enquiry or request you may have.
- Page 9 Technical data Name BATz 2.0 Partnumber CE10504 Display LED display red Controls 4x precision push buttons (OnOff / Rec / + / -) 1x Thumbwheel (Frequency) Receiver Electret measurement microphone Principle Heterodyne Frequency range 18 - 130 kHz Bandwidth 10 kHz (+/- 5 kHz) Internal recording 44.1kHz sample rate 8 Bit...
Need help?
Do you have a question about the Batz 2.0 and is the answer not in the manual?
Questions and answers