Charging Batteries - Lifestand LSR User Manual

User Manual LSR
Maintenance and repairs

Charging batteries

If the battery level falls too low, the control panel will emit an acoustic signal that
indicates that the batteries need charging. In that case, the battery has enough
power for a further 10 cycles. We recommend that the user return to sitting
position and charge the batteries before using this function again.
m CAUTION!
The batteries must be fully charged before using the wheelchair for the first time.
Note! Make sure that the power module is switched on before connecting the
charger.
1. Connect the charger cable to the control panel or the power module.
2. Connect the charger to a 230 volt wall socket. The light signal on the charger
is orange during charging. When the batteries are charged, a green light will
be displayed on the charger.
3. Once charging is complete, unplug the charger from the wall socket before
the cable is removed from the control panel or power module.
It takes between 4-5 hours to charge the batteries fully.
The charger cable is connected to the control panel.
49 49
Maintenance and repairs