Vertiv PSP500MT3-230U Quick Installation Manual

LIEBERT® PSP
Quick Installation Guide
IMPORTANT SAFETY
INSTRUCTIONS
• Do not connect equipment that
may overload the UPS or
demand half-wave rectification,
such as a laser printer.
• Connect the UPS only to an
earthed / grounded socket that
meets electrical safety
guidelines.
• Locate the UPS near a wall
socket. Do not use an extension
cord between the UPS and the
socket.
• Use CE-marked cables only for
connections between mains,
the UPS and equipment.
• The Liebert PSP has been
designed for small office/home
office use only; it is NOT
recommended for use in life-
support applications.
• In the event of an emergency,
press the On/Off button and
disconnect the power cord
from the AC mains to properly
disable the UPS.
• Do not attach power strips or
surge suppressors to the UPS.
• Do not attempt to service any
parts inside the UPS except
when replacing the batteries.
Failure to adhere to this could
cause personal injury or
equipment malfunction and
void the warranty.
• This unit uses components that
are dangerous for the
environment, such as electronic
cards and other electronic
components. Any component
that is removed must be taken
to specialized collection and
disposal centers. If this unit
must be dismantled, this must
be done by specialized
personnel who are properly
trained and qualified. The unit
TM
Liebert® PSP
TM
must be taken to a center
specialized in collection and
disposal of dangerous
substances.
For technical support: visit
www.vertivco.com
SETUP
1. Inspecting the package
Inspect the package and the
UPS upon receipt.
Notify the carrier and dealer of
visible damage.
The package includes:
• Liebert PSP
• USB cable
• Quick-start guide
• 2 IEC output cables
The Liebert MultiLink™
software may be downloaded
from the Liebert Web site at:
multilink.liebert.com
See Step 7 for installation
instructions.
UPS
2. Decide Where to Place the
3. Charging the UPS Battery
UPS
The UPS must be placed
indoors, protected from water,
direct sunlight and excessive
heat.
Provide at least 100mm (4") of
clearance on all sides of the
unit for proper ventilation.
before use
The UPS battery is not charged
before shipping. It MUST be
charged before use.
• Use the input power cord
from computer equipment as
the input power cord of UPS
Connect a user-supplied
power cord from the UPS to a
wall socket and charge for at
least eight hours. Unit can be
charged in the on or off state.
590-1631-501A\SLI-23285_REV1_11-17
1