Summary of Contents for Heat Electric Conservatory Radiator 3100
- Page 1 Heat Electric Radiators Installation and Operating Instructions Revision 0501M077.H Date 08/08/2012 INSTALLER PLEASE NOTE: LEAVE INSTALLATION AND OPERATING INSTRUCTIONS WITH CUSTOMER...
- Page 2 Document Heat Electric - Operator Revision Page 2 0501M077.H Date 08/08/2012...
-
Page 3: Table Of Contents
Setting the 7 day program Your RFC3 Unit Setting the Time and Day Factory Set Program Altering the Factory Set Program User Adjustment Trouble Shooting Guide 10.0 After Sales Service Document Heat Electric - Operator Revision Page 3 0501M077.H Date 08/08/2012... -
Page 4: This Manual Covers The Following Models
Installing more than one controller within a home allows for zoned controllability. They can be wall mounted, are battery powered and display the current and target room temperatures. RFC1 RFC3 Document Heat Electric - Operator Revision Page 4 0501M077.H Date 08/08/2012... -
Page 5: Important Health And Safety Information
The timer radiator is IP20 compliant and can be fitted in Zone 3. Warning Both the RF controlled and timer radiators must not come in direct contact with water. This includes excessive humidity or using wet hands to operate the controls. Document Heat Electric - Operator Revision Page 5 0501M077.H Date 08/08/2012... - Page 6 BSI to BS 1363. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard. Document Heat Electric - Operator Revision Page 6 0501M077.H...
-
Page 7: Installation Instructions
For optimum output, the bottom of the radiator should be 150mm from the floor. Any shelf or substantial projection should be a recommended minimum of 150mm above the top of the radiator. Document Heat Electric - Operator Revision Page 7 0501M077.H... -
Page 8: Fitting
If the bottom of the radiator is below the top of the skirting board, it may be necessary to remove a section of skirting for this purpose. Document Heat Electric - Operator Revision Page 8 0501M077.H... - Page 9 (B) to its original position, thereby securing the bottom of the radiator in its final position. A) Plastic Grommet A) Plastic Grommet B) Catch securing radiator B) Catch in lowered B) Catch in raised position position Document Heat Electric - Operator Revision Page 9 0501M077.H Date 08/08/2012...
-
Page 10: Operating Instructions
Note It is strongly recommended that radiators (all models) are run for ½ hour each month during the summer to ensure that the pump is fit for winter operation. Document Heat Electric - Operator Revision Page 10 0501M077.H Date 08/08/2012... -
Page 11: Manual Operation
24 hour clock: 8:00am = 8 on the dial 8:00pm = 20 on the dial Do not attempt to rotate the dial in an anti-clockwise direction. Current Time Document Heat Electric - Operator Revision Page 11 0501M077.H Date 08/08/2012... -
Page 12: Setting The Heating Times
, thereby allowing manual control of the output without disrupting the timed (tappet) settings. TIMED - Tappets Permanently OFF Warning The Permanently ON setting should not be selected for more than 24 hours at any one time. Document Heat Electric - Operator Revision Page 12 0501M077.H Date 08/08/2012... -
Page 13: Radio Frequency Control Options (Rfc1 And Rfc3)
Switch the radiator’s mains supply off. Switch the mains on for about 3 seconds then off again for 3 seconds. Switch the mains on and the radiator supply light will flash. Document Heat Electric - Operator Revision Page 13 0501M077.H... -
Page 14: Choosing A Position In The Room
Remove the wall plate from the rear of the RFC. Mark wall through the screw holes (60mm centres). Use the correct type of fitting for the wall and mount the wall using no. 6 or 8 screws. Clip the RFC onto the wall plate. Document Heat Electric - Operator Revision Page 14 0501M077.H... -
Page 15: Reverting Your Radiator To Manual Control
Frost Protection If used with the RF controller, the controller can be used to set the radiator to the frost protection mode. Ensure the thermostat knob is not turned off. Document Heat Electric - Operator Revision Page 15 0501M077.H Date... -
Page 16: Cleaning
Do not use detergents, abrasive cleaners, or polish on the radiator as these may damage the finish. Wipe the radiator with a dry cloth to remove dust and marks. Note Only external cleaning is permitted. Document Heat Electric - Operator Revision Page 16 0501M077.H Date 08/08/2012... -
Page 17: Your Rfc1 Unit
CLEAR. advanced until adjust the minutes. program’s normal time or Boost ends when the timer until you press CLEAR. runs out or you can cancel it by pressing CLEAR. Document Heat Electric - Operator Revision Page 17 0501M077.H Date 08/08/2012... -
Page 18: Setting The Time And Day
- - -.The snowflake symbol appears if the actual temperature ever falls below 4°C. Celsius or Fahrenheit Pressing BOOST SET-BACK together changes Actual and Target temperature between Celsius Fahrenheit. Document Heat Electric - Operator Revision Page 18 0501M077.H Date 08/08/2012... -
Page 19: Setting The 7 Day Program
If you clear a prog it displays as --:--,--.-- °C and the program is ignored. From Stage 1 press CLEAR to clear a prog and press it again to un-clear it. Document Heat Electric - Operator Revision Page 19 0501M077.H Date... - Page 20 CLEAR returns to stage 1 Manual Operation If you clear all 6 programs in all 7 days, there is no program at all. The temperature control is done entirely by Quick Adjust. Document Heat Electric - Operator Revision Page 20 0501M077.H Date...
-
Page 21: Your Rfc3 Unit
If it has not succeeded after 3 minutes it stops trying but will retry each hour until the clock is set. You can force a retry by removing and reinserting the battery. If that does not succeed: Document Heat Electric - Operator Revision Page 21 0501M077.H... -
Page 22: Factory Set Program
On each weekday the target temperature is 21°C from 6:30am to 8:30am, then 4°C (frost protection) until 4:30pm, then it is 21°C until 11:00pm and finally 4°C until PROG.1 the next day. Document Heat Electric - Operator Revision Page 22 0501M077.H... -
Page 23: Altering The Factory Set Program
The effect is temporary; it reverts to program temperature on the next PROG. You can set it to - - - (no heating), anything from 16°C to 28°C, BOOST or HOLIDAY (4°C frost protection). Document Heat Electric - Operator Revision Page 23 0501M077.H... - Page 24 Pressing from - - - takes you to HOLIDAY (room not occupied) and heating is set to 4°C frost protection. The program is suspended until you press Document Heat Electric - Operator Revision Page 24 0501M077.H Date 08/08/2012...
-
Page 25: Trouble Shooting Guide
Supply light is Green and stays on Tuned to factory controller Follow instructions 6.2 Supply light Is alternating red-green One of the fail-safe safety devices Follow instructions 4.0 flashing. has operated. Document Heat Electric - Operator Revision Page 25 0501M077.H Date 08/08/2012... -
Page 26: After Sales Service
Should you experience any problems with your radiator do not try to rectify it yourself as this will invalidate the warranty. Please contact Heat Electric Ltd quoting the model and serial number of the radiator (this can be found on the lower left-hand side of the radiator) Warranty repairs made during the warranty period are warrantied for the remainder of the original warranty. - Page 27 Installer Notes Document Heat Electric - Operator Revision Page 27 0501M077.H Date 08/08/2012...
- Page 28 Heat Electric Limited Wainstalls Mill Wainstalls Road, Halifax HX7 2TJ Telephone +44(0)1422 231943 Fax +44(0)1422 240018 e-mail info@heatelectric-uk.com www.heatelectric-uk.com...
Need help?
Do you have a question about the Conservatory Radiator 3100 and is the answer not in the manual?
Questions and answers