Table of Contents
Advertisement
Test Set CMC 156
Generally: Make sure that the ventilation slots at the rear panel of the
CMC 156 are free and clear!
1. Connect the CMC 156 test set to the computer:
2. Connect the CMC 156 and the computer to the power supply. (Power
3. Power both units up. CMC 156: ON/OFF switch on the front panel.
4. For further actions, see the Installation in the appropiate software manual.
5. Start the software.
An extensive hardware test is carried out when the software is starting up. If
there is a hardware fault, the software will put out an appropriate message
after starting).
1
requirement for the connecting cable.
10
•
If the computer is equipped with a parallel printer port, use the 25-pole
cable (VEHK0002)
CMC 156 to the computer.
•
If the computer is equipped with a USB port, use an OMICRON
CMUSB-P converter (ordering number VEHZ2007) instead of the
VEHK0002 to connect the CMC 156 to the computer.
supply cable is supplied.)
Only original centronics cable may be used due to the electromagnetic compatibility (EMC)
1
that was supplied with the test set to connect the
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the CMC 156 and is the answer not in the manual?
Questions and answers
Hi We want to purchase VEHZ2007 Cable Qty 1 nos
Why the overload current light is red when we switch it on
The overload current light on the Omicron CMC 156 turns red when an overload occurs at one of the current or voltage outputs. This triggers a corresponding display in the CMC software, indicating the overload condition. Additionally, if the device switches off due to overtemperature caused by a low ohmic burden with a high ON period, messages such as "Overtemperature at voltage output!" or "Overtemperature at current output!" appear, and all voltage (V) and current (I) outputs are switched off.
This answer is automatically generated