NOTICE
In particular cases, you may be allowed to select a display type or a parameter only in the upper
display. See section 0, "LOCK displays".
3.4.3
How to explain displays in run mode
3.4.3.1 For a selection either on the upper display and/or on the lower display
ANALOG INPUTS
•
Analog input numbers, measured values and sensor engineering units will be displayed.
AN 0 1 1 2 4 . 2
AN = mnemonic for analog input
Two printed channels on the same display
•
0 1 2 4 . 2 & 2 4 . 3
01: channel number
24.2: channel value of channel 1
24.3: channel value of channel 2
Note that the second channel number is incremented by 1 from the first channel number.
If, for example, the first channel is not configured, no value will be displayed, e.g.
0 3
& 2 4 7 . 2
COMMUNICATION CHANNELS
•
COM 0 1 2 5 4 . 9
COM = mnemonic for communication channel
•
ALARMS
•
For each operated alarm, alarm number, alarm state, relay number, relay state, channel type and channel
number will be displayed.
o
C
3-5
3. OPERATION