Binary Pitch Mode (Option) - Devicor Neoprobe neo2000 Operation Manual

Artwork No: AW-000639 Revision: A Artwork Status: Released Lifecycle Name: Artwork
Operational Note
Events that may occur during product use:
If....
Target Count Button [11] is pressed while
Target Count is calculated
Target Count is too high
Target Count Button [11] is pressed while
Target Count or 10 Second Count is
displayed
Calculated Ratio is greater than 99.9

4. BINARY PITCH MODE (OPTION)

Binary Pitch Mode sound tells physician when radioactivity is significantly above Background Count of
nonradioactive area.
To......
Turn system on
Conduct
performance
check
Select Binary
Pitch Mode
Select different
AW-000639
PCO No: N/A ECN No: ECN-000214 Release Date: 10/09/2012 Effective Date: 10/09/2012
neoprobe
Perform following......
Press and release power standby button [1] Power indicator is lit.
See instructions below
Press and release Binary Pitch/Dynamic
Pitch Button [4]
Press and release Radionuclide Selection
TM
GDS Operation Manual
Then this occurs.....
Target Count restarts
Overflow Symbols"/////" displayed on
Target Count Readout [7] and varying beep
is heard
Target Count function returns to Dynamic
Pitch Mode and displays Count Rate data
Overflow symbol "///" is displayed [9]
And this occurs....
All LEDs are lit
System should begin normal operation
within 20 seconds
Operation of BLUETOOTH
"no linc" indicates problem with probe,
console or serial port adapter. See
troubleshooting instructions below.
For a cabled probe: If there is no probe or
cable attached message "error no Probe" is
displayed. See troubleshooting instructions
below.
System function indicator lights and
"error 2" through "error 6" are
displayed. See troubleshooting instructions
below.
Binary Pitch Symbol is lit
Background Count changes to 7 counts per
second
Radionuclide automatically set
radionuclide symbol is lit
Desired radionuclide is lit
Page 13 of 38
/////
////
®
: message
99m
Tc, and