TerraMarNetworks trac6140 Installation Manual

Installation Guide
This is a bespoke installation guide for the TerraMar Networks | trac6140/ 6141/ 6142 tracking device (referred to as the "Device" in this document.) If in any doubt,
please consult the tracpoint support team, using the contact details shown at the end of this document.
trac6140 – Includes standard wiring loom 12V/24V compatibility
trac6141 – Includes ACCY1056 Complete Accessory wiring loom 12V only (voltage label will be included on loom)
trac6142 – Includes ACCY1075 Complete Accessory wiring loom 24V only (voltage label will be included on loom)
1. BOX CONTENTS
Please ensure all the following parts are present before beginning the installation of the Device:
STANDARD PARTS – See Figure 1
 trac6140 Device
 Basic Loom (attached)
 Phantom ignition sensor
 GPS antenna
 Fuse holders x3
 Fuses x3 (1amp – 2amp – 5amp)
 Tamper stickers x5
 Cleaning pad
EXTRA PARTS AVAILABLE BY REQUEST/ORDER
 Driver ID (ACCY1073) – see Figure 2
 Panic Button (ACCY1012/ACCY 1013) – see Figure 2
 Immobilisation circuit (ACCY1010) – see Figure 2
 Complete Accessory loom 12V (ACCY1056) – see Figure 3 – includes phantom ignition sensor (PIS)
 Complete Accessory loom 24V (ACCY1075) – see Figure 3
1 | P a g e
I-021 - trac6140/1/2 - Installation Guide Ver. 2.1
Fig 1: Standard Parts
tracpoint | Support Team