Page 2
Notice 1- This is a ‘Universal’ child restraint for Group I (9-18kg), and Semi-Universal child restraint for Group II (15-25kg). It is approved to Regulation No. 44,04 series of amendments, for general use in vehicles and it will fit most, but not all, car seats. 2- A correct fit is likely if the vehicle manufacturer has declared in the vehicle handbook that the vehicle is capable of accepting a child restraint for this age group.
Page 3
Notice WARNING: This installation must only be performed by a competent adult. Don’t try to install the seat when intoxicated or drowsy. WARNING: Always ensure that new or occasional users [e.g. grandparents] have read the instructions or been taught the correct installation by someone who has read and understood the instructions.
Page 4
Notice WHEN USING THE CHILD CAR SEAT WARNING: Make sure that the child car seat is placed somewhere so that rigid items and plastic parts do not become trapped in doors or movable seat units when the seat is in everyday use. WARNING: Always use the vehicle’s door child safety lock system, if one is available, to make it impossible for the child to open the car doors from inside.
Page 5
Notice SEAT BELT WARNING: NEVER use any load bearing contact points other than those described in these instructions or marked on the child car seat. WARNING: Ensure that the lap section of the seatbelt or harness is worn low down, so that pelvis is firmly engaged.
Page 6
Notice SECOND HAND OR DAMAGED CHILD CAR SEATS AND SEATBELTS WARNING: Never buy a second hand child car seat. It may have unseen damage. WARNING: The manufacturer only guarantees this product when the original owner uses it. WARNING: You MUST replace the child car seat and your vehicles seatbelts if they become badly worn or amaged.
Page 7
Contents Welcome Parts checklist Positioning the seat Four-position seat recline Installing for group I (9-18kg) Adjusting the headrest and harness height Placing your child in the seat - group I (9-18kg) Converting for groups II [15-25kg] Installing for groups II [15-25kg] Removing the seat cover Replacing the seat cover Replacing the harness...
Page 8
I/II instructions carefully before use to ensure safe and satisfactory operation of this product. Your chuild’s safety is your responsibility.If you have a query with this product or require replacement parts,please contact your nearst retail store.
Page 9
1) The car seat can be used with isofix anchors and top tether for group 1 (9-18kg child). 2) The car seat must be used with an ISOFIX anchor and top tether as well as a 3-point seat belt for group 2 (15-25kg child). The child car seat can be secured in a forward- facing position in the rear seats of the vehicle by using the existing seatbelts.
Page 10
a) Place the car seat on the vehicles seat Rotate adjuster button in an anti-clock wise direction(A),and pull the isofix anchors outwards as far as it goes, make sure it cannot be pushed back (B) c) Push the car seat towards the back of vehicles seat(A) Push d) Match the isofix anchors to the vehicles anchoring...
Need help?
Do you have a question about the Storm isofix and is the answer not in the manual?
Questions and answers