System Reset - Atlona AT-HDVS-150-RX Manual

Setting
F/W
HV Total
HV Display
HV Polarity
Scan Mode
Type
HDCP
Clock
Sync
Identity
Type (Audio)
SR (Audio)
FIFO (Audio)

System Reset

The System Reset menu provides the ability to reset the AT-HDVS-150-RX to factory-default settings.
1. Under the Main Menu, highlight the System Reset menu item using the UP/DN buttons on the front panel.
2. Press the MENU button.
3. The System Reset menu will be displayed.
System Reset
No
Yes
Menu Back
4. Press the UP/DN buttons to highlight the desired option.
5. Press the MENU button to confirm the selection.
6. Highlight the Menu Back option, then press the MENU button to return to the Main Menu.
AT-HDVS-150-RX
Description
Indicates the firmware version of both the transmitter (TX) and receiver
(RX). If the TX is not connected, then "Unknown" will be listed next to
the TX field.
The total number of horizonal and vertical pixels.
The display resolution.
Polarity of both the horizontal and vertical sync pulse.
The scan mode - either progressive or interlaced.
The type of video signal.
Indicates whether or not if HDCP content is present.
Indicates whether the source status of the TMDS clock is detected (On)
or has been lost (Off).
Indicates whether the source status of the TMDS sync is detected (On) or
has been lost (Off).
Displays the detected resolution of the source.
Displays the audio format.
Displays the sampling rate of the audio signal.
Displays the status of the FIFO audio buffer.
Menu System
23