Assembly And Set-Up; Charging The Battery; Attaching The Handlebars - Razor DIRT QUAD 25117460 Owner's Manual

ASSEMBLY AND SET-UP

Charging the Battery

Your electric four wheeler may not have a fully charged battery; therefore it is a good idea to charge the
battery prior to use.
• Initial charge time: 12 hours
• Run time: up to 40 minutes
• Average battery life: 250 charge/discharge cycles
Charger
Port
Charger
Plug

Attaching the Handlebars

1
Using the 6mm hexagonal
key wrench, remove bolts
from handlebar clamp.
• Recharge time: Always remember to turn the
power switch off and recharge for at least 8 hours
after each use. When vehicle is not in regular
use, recharge battery at least once a month until
normal use is resumed. If you have left the power
switch on or your product has not been charged
for a long period of time the battery may reach a
stage at which it will no longer hold a charge.
1
Align the groove on the plug
of the charger port and plug
into the port on the Dirt Quad.
Tighten the threads to secure
the plug. The charger works
with the power switch in either
the on or off position.
2
Place handlebars in handle-
bar clamp in upright, vertical
position.
2
Plug the charger plug into a
wall outlet.
3
Insert bolts and tighten
securely. When properly
tightened, the handlebars
should not move forward or
back. Note: The gap between
the upper clamp and lower
clamp should be equal on both
sides of handlebar.
3
WARNING:
Always disconnect your electric
four wheeler from the charger
before cleaning with liquid.
Note: If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifications and charging
procedure would not change.
The charger has a small window
with one LED or two LEDs to
indicate the charge status. Refer
to the illustration on the charger
unit for the actual "charging" and
"charged" status indications for
your model charger.
Chargers have built-in over-charge
protection to prevent battery from
being over-charged.
Be sure to properly align the
groove on the charger input
port with the corresponding
socket on the Dirt Quad and
tighten threads; otherwise, no
charging action will occur.
WARNING:
Failing to properly adjust and
tighten the bolts that affix the
handlebars can cause you to
lose control and crash.