Programmable Output Function List - THOMSON TSC 900 Installation, Operating & Service Manual

5.9.5. PROGRAMMABLE OUTPUT FUNCTION LIST

The following output functions can be mapped to any programmable output. Note:
outputs can be programmed multiple times to provide additional output contacts of same
type.
TagName
alm.any
alm.gen.failtorun.1
alm.gen.failtorun.2
alm.gen.muststart.1 Gen 1 Standby Source Failed to Start
alm.gen.muststart.2 Gen 2 Standby Source Failed to Start
alm.onsrc.1
alm.onsrc.2
alm.xfr.detect.1
alm.xfr.detect.2
alm.xfr.fail
alm.xfr.mech.1
alm.xfr.mech.2
alm.xfr.sync
alm.xfr.sync.ext
alm.xfr.trip.1
alm.xfr.trip.2
alm.xfr.unload.1
alm.xfr.unload.2
ctl.auto
ctl.breaker.1.trip
ctl.breaker.2.trip
ctl.discon.req.a
ctl.discon.req.b
ctl.disconnected
ctl.goto.discon
ctl.goto.man
ctl.halted
ctl.ldc
ctl.ldc.post
ctl.ldc.pre
ctl.manual
ctl.off
ctl.off.req.a
ctl.off.req.b
ctl.onsrc
ctl.onsrc.1
ctl.onsrc.2
ctl.outputs.o01
ctl.outputs.o02
PM 151 REV 5 16/04/19
TSC 900 TRANSFER SWITCH CONTROLLER
TagDescription
ATS Common Fail Alarm
Gen 1 Failed While Running
Gen 2 Failed While Running
Src 1 Fail to Transfer Common Alarm
Src 2 Fail to Transfer Common Alarm
Load on Src 1 Limit Sw/Aux Contact Failure
Load on Src 2 Limit Sw/Aux Contact Failure
ATS Fail to Transfer Common Alarm
Src 1 Fail to Open/Close Alarm
Src 2 Fail to Open/Close Alarm
Fail to Drift Sync Timeout
Fail to Externally Auto Sync Timeout
Loss of Load Voltage - Src 1 Contacts Open
Loss of Load Voltage - Src 2 Contacts Open
Src 1 Fail to Unload
Src 2 Fail to Unload
Controller in Auto
SRC 1 Trip Breaker
SRC 2 Trip Breaker
Service Disconnect Mode Activated
Disconnect Request (GHC)
Service Entrance Disc. Init
Disconnect All Sources
De-Energize All Sources
System Halted
Load Disconnect Contact (Pre/Post Transfer)
Load Post-Disconnect
Load Pre-Disconnect
Control Manual
Control Off
Non-Auto Off Request (Remote)
Non-Auto Off Request (GHC)
Load on Either Source
Load on SRC 1
Load on SRC 2
User Def Output 1
User Def Output 2
73
Thomson Power Systems