Hyper Pearl User Manual

2. Charging your devices with Pearl
* Insert your device's USB charging cable
into Pearl's USB output port
* Insert the other end of the USB charging
cable into your device
* Your device should indicate that charging
has started
3. Mirror LED ring light
Pearl has a built-in LED ring light around the
3X magnification mirror, which can be turned
ON/OFF by double pressing the button.
Charging your device

Troubleshooting

Please use the following steps if Pearl cannot charge your device.
(
1. Verify that Pearl has been completely charged. You may need to charge it
for a while to activate it)
2. Check that the USB charging cable is properly connected to the Pearl.
3. Check that your device has its battery installed (Some devices cannot work
without an installed battery)
4. Check whether your device can support 5V (2.1A max) charging. If not,
Pearl cannot power your device.
Notice:
Please do not disassemble or short circuit battery.
Pearl
User Manual