Replacing Fuses; Fuse Replacement; Cleaning - IDEAL INDUSTRIES 61-310 Technical Manual

Replacing Fuses

To avoid electrical shock, remove the test leads and any input signals before replacing
battery or fuses.
To prevent d amage or injury, INSTALL ONLY quick acting fuses with the following Amp/Volt
current interrupt rating:
F-310 Fuse: 250mA 250V FAST BLOW
Fu se Replacement
The 61-310 replacement fuse is part number: F-310
Fuse Rating is: 250mA 250V FAST BLOW
1. Remove the rubber holster.
2. Remove the two screws on the battery cover and open the battery cover.
3. Remove the two screws under the battery cover.
4. Lift up on the back
•
Replace the defective fuse with the standard rated fuse for this meter.
5. Retu rn the back case cover, reinsert the case screws.
•
It is recommended to
6. Return the battery cover and reinstall the two battery cover screws.
7. Replace the rubber boot.
Caution
Use only a fuse with the amperage, interrupt voltage, and speed rating
specified.

Cleaning

To avoid electrical shock or damage to the meter, never allow water inside the case. To avoid
damaging the meter's housing, never apply solvents to the meter.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
FAX 781.665.0780 - TestEquipmentDepot.com
Form Number TM61310
Warning
Fuse
case until the case unsnaps from the front case near display.
replace the old battery with a new battery.
Warning
Rev 2 Aug 2007
Page 9
the