Pairing Your Mylifter Unit With Your Ios Or Android Device - myLIFTER GARAGE SMART User Manual

24
CAUTION
If your unit is mounted perpendicular to the joist,
the eye screw must be placed on the same side as
the opening in the cable guide (the side where the
cable hangs when it is fully coiled) (Figure 4.2b). This
prevents the fully raised cable from contacting the
myLIFTER unit and causing cable damage.
5. Assemble the lifting hooks, hook bolts, hook washers, and
hook nuts to the pulley block as shown in Figure 4.3.*
6. Cut the zip tie holding the cable on your myLIFTER unit.
Route the cable through the pulley block and attach the cara-
biner (M) to the end of the myLIFTER cable.
*These parts are included with the base kit and bike kit. This step may not be
necessary if you have purchased a kayak kit or hardtop kit.
7. Clip the carabiner to the mounted eye screw (J).

5 Pairing Your myLIFTER Unit with Your iOS or Android Device

1. Download the myLIFTER app to your smart device from either
Google Play or the App Store.
Eye screw (J)
2. The indicator light on your myLIFTER unit should be a slow
Figure 4.2b
blinking yellow, indicating that the unit is idle. Open the app,
and tap the
The number in parentheses indicates the number of nearby
detected myLIFTER units (Figure 5.1).
3. A dialog box will appear and tell you to press the
on your myLIFTER unit. Tap OK. Your myLIFTER unit's indicator
light should change to a faster blinking yellow.
Figure 4.3
Add New button in the bottom right corner.
PAIR button
25
Figure 5.1