Advertisement
Quick Links
Advertisement
Related Manuals for Marshall Amplification MG10 Gold
Summary of Contents for Marshall Amplification MG10 Gold
- Page 1 OWNER’S MANUAL...
- Page 2 INTRODUCTION WARNING! IMPORTANT SAFETY INSTRUCTIONS Congratulations on your purchase of this MG Gold amplifier from Marshall Amplification. WARNING: IMPORTANT SET UP INFORMATION: Before going any further, make sure that your amplifier is compatible with your WARNING: The MG provides modern Marshall tones for the player who is on the go.
-
Page 3: Compliance Statement
COMPLIANCE STATEMENT MG10 FRONT PANEL FUNCTIONS (MG15FX, MG30FX & MG50FX) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation. - Page 4 MG15FX & MG30FX FRONT PANEL FUNCTIONS 1. INPUT JACK SOCKET 7. TREBLE CONTROL preset mode. When using the optional 15. FOOTCONTROLLER SOCKET Input for your guitar. Use a good quality Increasing the Treble will make your footcontroller, holding both the Tap ¼”...
- Page 5 MG15FX & MG30FX OVERVIEW (13) which is not storable, will now not reverb options - Studio or Spring When CHANNEL SELECTION MP3 / LINE IN The amplifier has 4 channels - Clean, match the actual settings of the amplifier. the Reverb control (8) is set to ‘0’ the The 3.5mm MP3 / Line In socket (14) Crunch, OD-1 &...
- Page 6 MG50FX FRONT PANEL FUNCTIONS 1. INPUT JACK SOCKET 8. REV SWITCH 14. DELAY CONTROL 20. POWER SWITCH Input for your guitar. Use a good quality Switches the reverb effect on and off. Controls the amount of signal sent to any The power switch turns your amplifier guitar cable (i.e.
- Page 7 MG50FX REAR PANEL FUNCTIONS 1. MAINS INPUT CONNECTOR 4. MP3 LINE IN SOCKET Your amp is provided with a detachable Jam to your favourite track by connecting mains (power) lead, which is connected the line out or headphone output of your here.
- Page 8 MG50FX OVERVIEW which is not storable, will now not match time to the time between two presses. CHANNEL SELECTION The amplifier has 4 channels - Clean, the actual settings of the unit. All front The FX control is essentially split into five Crunch, OD1 &...
-
Page 9: Foot Controller
MG50FX OVERVIEW FOOTCONTROLLER STOMPWARE PEDL-90008 (OPTIONAL) FX LOOP power amp. When using external cabinets The FX Return socket (25) on the rear ensure the total load impedance is equal panel is used to connect the OUTPUT of to, or exceeds, 8 ohms. EXT FX DAMP the effects processor or pedal you are... - Page 10 FOOTCONTROLLER NOTES STOMPWARE PEDL-90008 (OPTIONAL) CONT. Pressing only the Store switch at this the footswitch has been assigned. You point will overwrite the altered Channel or can then release the footswitch and front Footswitch preset. panel switch. To store an altered Channel preset to the MG50CFX Footswitch instead, hold the Store switch By simultaneously pushing the Damping...
- Page 11 Registered in England. Registered Number: 805676 Whilst the information contained herein is correct at the time of publication, due to its policy of constant improvement and development, Marshall Amplification Plc reserves the right to alter specifications without prior notice. BOOK-90033-v.02...
Need help?
Do you have a question about the MG10 Gold and is the answer not in the manual?
Questions and answers