Configuring Vxlan Bgp Evpn; Bgp Evpn And Overlay Configuration - Cisco Nexus 7000 Series Configuration Manual

Configuring VXLAN BGP EVPN

Feature
vPC FEX
(A-A/S/T)
Auto Config
ARP
Suppression
Configuring VXLAN BGP EVPN

BGP EVPN and Overlay Configuration

The following BGP, EVPN and overlay configurations are required for the Cisco Nexus 7000 Series and 7700
Series switches with F3 and M3 modules:
1 Initial configuration - Install the network virtualization overlay, BGP, and EVPN features on the VTEPs.
2 Layer 2 VNI configurations for tenant networks within a tenant.
(This configuration is applicable only to F3 modules).
3 Layer 3 VNI configurations for a tenant.
Note Though configuration examples are mainly IPv4, IPv6 addresses are also supported in the VXLAN EVPN
fabric.
Cisco NX-OS Release 7.2(0)D1(1) supported only the border spine functionality. Cisco NX-OS Release
7.3(0)DX(1) supports the Cisco Nexus 7000 leaf functionality for F3 modules.
Initial configuration
(config) #
install feature-set fabric
feature-set fabric
feature fabric forwarding
feature interface-vlan
feature ospf
OR
feature isis
You can use either OSPF or IS-IS as the underlay routing protocol.
Attention
Cisco Nexus 7000 Series NX-OS VXLAN Configuration Guide
56
Cisco NX-OS Cisco NX-OS
Release Release
7.2(0)D1(1) 7.3(0)D1(1) (F3
Modules)
Not Supported Supported
Not Supported Supported
Not Supported Supported
Configuring VXLAN BGP EVPN
Cisco NX-OS Cisco NX-OS
Release Release
7.3(0)DX(1) (F3 7.3(0)DX(1) (M3
Modules) Modules)
Supported Not Supported
Supported Not Supported
Supported Not Supported
Cisco NX-OS
Release 8.0(1) (M3
Modules)
Not Supported
Not Supported
Supported