Network Communication Interfaces - Dell Edge 3000 Installation And Operation Manual

S S ystem PowerOff
Run the following command:
The system shuts down successfully.

Network communication interfaces

The Edge Gateway 3000 series comes with one Ethernet connection, one 802.11b/g/n wireless network connection, and one
Bluetooth network connection.
Ethernet (Port 1, eth0)
Assuming that you have an internet-enabled Ethernet cable plugged into Port1, your screen should be similar to the one below after
running the command. If the WLAN and Bluetooth are not configured, they are not displayed in the network device list.
After running the
WLAN (wlan0)
Use these identifiers in the following examples:
•
•
•
• , where
Enter the following at the command prompt to view the network interfaces.
Enter the following at the command prompt to find a list of available access points.
Run the following commands and replace $SSID, $PSK, and $WIFI_INTERFACE of your environment.
• Connect
OR
54
command:u
, where is the name of access point.
, where is the connection name, which is basically a connection identifier.
, where is the WLAN key management security type being used.
is the WLAN passcode or password for the access point.