Fujitsu ASU18RLF Service Instructions Manual page 16

For Floor Type < AGU9/ 12/ 15RLF >
1. VERTICAL LOUVER CONTROL
(Function Range)
Each time the button is pressed, the air direction range will change as follow :
The Remote Controller's display does not change.
Use the air direction adjustments within the ranges shown above.
The vertical airflow direction is set automatically as shown,
in accordance with the type of operation selected.
Cooling / Dry / Fan mode Horizontal flow
Heating mode
When the temperature of the air being blown out is low at the start of heating operation or during
defrosting, the airflow direction temporarily becomes
During Monitor operation in AUTO CHANGEOVER mode, the airflow direction automatically
becomes , and it cannot be adjusted.
2. ADJUST THE RIGHT-LEFT LOUVERS
Move the Right-Left louvers to adjust airfow in the direction you prefer.
( Fig. 10 : Air direction range )
3. SWING OPERATION
To select Vertical Airflow Swing Operation
When the swing signal is received from the remote controller, the vertical louver starts to swing .
( Table 6 : Swinging range )
The type of operation
Cooling / Dry / Heating / Fan mode
When the indoor fan is either at S-Lo or Stop mode, the swinging operation is interrrupted
and it stops at either upper end or bottom end.
To select Horizontal Airflow Swing Operation
(No function)
Downward flow
to prevent cold air being blown onto the body.
Range
01-13
( Fig. 9 : Air direction range )