JVC KD-AV7100 Installation & Connection Manual page 2

When using the stay
Dashboard
When installing the unit without using the sleeve
In a Toyota car for example, first remove the car radio and install the unit in its place.
g/h
Pocket
1
* Not included for this unit.
ELECTRICAL CONNECTIONS
To prevent short circuits, we recommend that you disconnect the battery's negative terminal and make all electrical connections before installing the unit.
• Be sure to ground this unit to the car's chassis again after installation.
PRECAUTIONS on power supply and speaker connections:
• DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be seriously damaged.
• BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your car.
Washer
* 1
j
g/i
b
Bend the supplied stay.
g/h
Bracket
* 1
Fire wall
Lock nut
* 1
m
1 2 3 4
5 6 7
Use the supplied screws
For No.1 – 4
For No.5 – 9
Note :
When installing the unit on the mounting bracket, make sure to use the
supplied screws. Using other screws (than supplied ones) may damage the unit.
2
Install the unit at an angle of less than 30˚, taking it into
account that the monitor would eject when in use (see
below).
Required space for the monitor ejection
Unit: mm
167
110˚
50˚
8 9
M4 x 2.5 mm
M5 x 5 mm
33
2.5
43
44