Table of Contents
Advertisement
Diagram 1B
Boundary Setup
Unwind the boundary cord onto the playing
area. The boundary is pre-measured with
the center pole markers and four corner
anchors. The standard and current volley-
ball court dimensions are 30' x 60' [Diagram
1C].
Pole Maintenance - Separate pole sections and remove all dirt, sand, and debris
to prevent the poles from jamming.
Net Adjustment - If net adjustment is required, this can be done by increasing the
amount of top rope slack. Nets will require the removal and re attachment of the
metal clip located in the top net tape.
Lean the base of the pole towards the inside
center of the court approximately 18", Pull-
down on the guyline tension ring or handle.
Stand the pole upright. This procedure provides
maximum net tension [Diagram 1B].
www.parksun.com • info@parksun.com
Net Tensioning
Tips
Diagram 1C
Advertisement
Table of Contents
Need help?
Do you have a question about the Spectrum Classic and is the answer not in the manual?
Questions and answers