Heath Zenith 7750 Manual page 2

2
Figure 4
Figure 5
Helpful Videos – www.hzsupport.com
5. Mount push button. Use either screws or
double sided tape to mount push button.
• Screw Mounting: To mount with screws,
remove back of case by pushing in tab
on bottom with a small screwdriver (see
Figure 1). Note: Remove material in screw
holes (if needed) before mounting with
screws. Attach back of case to door jamb
or wall (see Figure 4). Snap front of push
button on.
• Tape Mounting: When attaching push but-
ton using double sided tape, make sure the
surface of the door jamb or wall is clean.
6. Mount chime. Determine mounting location.
• Drill 7/32" diameter pilot hole for wall anchor.
• Mount keyhole screw to wall leaving about
1/8" (3 mm) of the screw threads exposed.
• Using keyhole on back of chime base, hang
base on screw (see Figure 5).
• Note: For additional mounting security, re-
peat the above steps to install two additional
screws through the other two holes in the
chime back.
7. Snap chime cover onto chime base. Align
top edge of case with top of back plate. Rotate
bottom of case toward back plate and snap
into position.
Helpful Answers – 1-800-858-8501