Table of Contents
Advertisement
2) To drive the compactor forward, push the travel lever to the forward position (see below).
3) To drive the compactor backward, pull the lever to the reverse position.
Do not move the travel lever with excessive force when engine is turn-off. The lever should move easil
y when the engine is started and the compactor is operating normally. If the lever does not move easi
ly, see the troubleshooting section for the solution.
NOTE:
If the compactor does not move in reverse, even when the travel lever is put in reverse, set
the engine throttle lever to low, and repeat moving the travel lever between forward and reverse 15-20
times. When resistance in the lever is felt, move the throttle lever to the fast position and operate the
compactor.
4) Grip the handle firmly as the compactor moves.
5) While compacting, look for debris that might damage the compactor or cause bodily harm.
6) Reduce travel speed when compacting clay so the compactor will not bounce off the ground if cla
y builds up underneath the compactor.
To correct this situation:
-
(With the compactor turned off) check under the compactor to determine whether clay or
other material has become stuck to the vibrator plate.
ater and remove the material.
-
Remember that the compactor cannot do effective work on clay or very moist soil.
-
If the soil is very moist, dry it to a suitable level or perform compaction twice.
If so, clean the plate/mechanism with w
Page 14 of 28
Advertisement
Table of Contents
