Show Ip Arp - Cisco Nexus 5500 Series Command Reference Manual

show ip arp

show ip arp
To display the Address Resolution Protocol (ARP) table statistics, use the show ip arp command.
Syntax Description client
statistics
summary
ethernet
slot/[QSFP-module/]port
loopback intf-num
mgmt mgmt-intf-num
port-channel
channel-num
vlan vlan-id
fhrp-non-active-learn
static
detail
vrf
vrf-name
all
default
management
Command Default None
Command Modes
EXEC mode
Cisco Nexus 5500 Series NX-OS Security Command Reference
280
show ip arp [client | [statistics | summary] [ethernet slot/[QSFP-module/]port | loopback intf-num
| mgmt mgmt-intf-num | port-channel channel-num | vlan vlan-id] [fhrp-non-active-learn]
[static] [detail] [vrf {vrf-name | all | default | management}]]
(Optional) Displays ARP information for ARP clients.
(Optional) Display the global ARP statistics on teh switch or the ARP
statistics for interfaces.
(Optional) Display the ARP adjacency summary information.
(Optional) Displays the ARP information for an Ethernet interface. The
slot number is from 1 to 255. The QSFP-module number is from 1 to 4. The
port number is from 1 to 128.
Note
(Optional) Displays the ARP information for a loopback interface. The
loopback interface number is from 0 to 1023.
(Optional) Displays the ARP information for a management interface.
The interface number is 0.
(Optional) Displays the ARP information for an EtherChannel interface.
The channel number range is from 1 to 4096.
(Optional) Displays the ARP information for a specified VLAN. The
range is from 1 to 4094, except for the VLANs reserved for internal use.
(Optional) Displays the ARP table information learned only due to a
request for a nonactive Cisco First Hop Redundancy Protocol (FHRP)
address.
(Optional) Displays the static ARP entries.
(Optional) Displays the detailed ARP information.
(Optional) Specifies the virtual routing and forwarding (VRF) to use.
VRF name. The name can be a maximum of 32 alphanumeric characters
and is case sensitive.
Displays all VRF entries for the specified VLAN in the ARP table.
Displays the default VRF entry for the specified VLAN.
Displays the management VRF entry for the specified VLAN.
The QSFP-module number applies only to the QSFP+ Generic
Expansion Module (GEM).
Chapter Show Commands
OL-27883-02