Table of Contents
Advertisement
Heater Start-Up Procedure (continued)
Display current fault in the fault memory again
3.
Simultaneously press Left and Right arrow keys.
a.
Display: e.g. AF: 12
Delete the fault memory and as a result, at the same time cancel the control box lock
Current fault or fault F1 – F5
Clear all faults and cancel control box lock by pressing OK key.
dEL will display.
Press OK key again to confirm deletion.
The fault memory is deleted and the control box is unlocked.
Continue with Heater Start-Up or Diagnosis.
Quit Start-Up
Switch off heater
Press the OK key, heater is switched off.
Perform the diagnosis again
Press the ON/OFF key, display is activated.
Unable to perform the diagnosis
Automatic detection was unsuccessful
Display if the automatic detection was not successfully completed.
Possible causes:
• Diagnostic harness not connected to heater harness
• Adapter plug not seated in diagnostic harness
• Defective diagnostic cable
• Defective heater.
65
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TriPac Envidia and is the answer not in the manual?
Questions and answers