LCD Jumbo Display Dual Timer/Clock
Your RadioShack LCD Jumbo Display Dual
Timer/Clock is a precise, dual-purpose time-
piece. Both timers can count hours, minutes
and seconds, up or down, from a specified
time. The metal stand lets you set the timer/
clock on a desk or table, and the clip and
magnet let you attach it almost anywhere.
Countup Timer — counts up to 29 hours, 59
minutes and 59 seconds.
Countdown Timer — counts down from 29
hours, 59 minutes and 59 seconds.
Minute and Second Increments — let you
count even small amounts of time.
Alarm — alerts you when the countdown
time elapses.
INSTALLING THE BATTERY
Your must install the supplied LR44 button-
cell battery before using your timer/clock.
1. Insert
a
coin
into the groove
on the battery
compartment
cover, turn the
coin
counter-
clockwise, and
remove
the
cover.
2. Insert the battery with the positive ( )
side facing up. The timer/clock beeps.
3. Replace the cover.
OWNER'S MANUAL — Please read before using this equipment.
Cautions:
• Keep button-cell batteries away from
children. Swallowing a button-cell
battery can be fatal.
• Dispose of old batteries promptly and
properly. Do not burn or bury them.
Notes:
• If the timer/clock does not work when
you install the battery, remove and re-
install it.
• When the display dims or the alarm
weakens, replace the battery. For the
best performance and longest life, we
recommend using a RadioShack
alkaline battery.
SETTING THE CLOCK
1. Repeatedly press
appears in the upper left corner.
MINUTE
HOUR
CLEAR
TIMER 2
2. Hold down
until the display flashes.
Note: Repeatedly press
change between a 12- and 24-hour for-
©
2001 RadioShack Corporation. All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
until
CLOCK
MODE
SECOND
MODE
TIMER 1
for about 2 seconds
CLEAR
CLEAR
to
Need help?
Do you have a question about the 04A01 and is the answer not in the manual?
Questions and answers
How do you stop the beep from sounding on dual timer (RadioShack)
To stop the beep on the RadioShack dual timer 04A01 when the timer reaches 0:00:00, press TIMER 1 or TIMER 2, then press CLEAR.
This answer is automatically generated