Page 1
INSTRUCTIONS MANUAL FOR USE AND MAINTENANCE Carbel models: Plus ■ C-60 Plus ■ C-70 Plus ■ C-80 Plus ■ C-100 Plus ■ C-70 Double-sided Plus ■ C-80 Double-sided Plus ■ C-100 Double-sided CARBEL C/ Ciudad de Cartagena, 22 46988 Polígono Industrial Fuente de Jarro (Paterna) Valencia Tel.
NOTE FROM THE MANUFACTURER Thank you for choosing one of our models. Please read this manual carefully. It has been written to give you tips on installation, use and maintenance. If you need further clarification, please contact your dealer or the manufacturer directly.
Page 3
- When a metal chimney is fitted inside a brick chimney, it must exceed the height of the latter and protrude a few centimetres at the top. - The installation of the pipe and cap must strictly prevent water from getting into the appliance on rainy days. Water causes more damage to woodburners than the high combustion temperatures for which they are prepared.
The building work must be finished in such a way that the woodburner can expand during operation: the brickwork must never be supported on or against the sides of the appliance. Leave a minimum expansion joint of 0.5 cm on each side and at least 1 cm the top of the front.
Page 5
3. After a certain period of time, which varies depending on the type of firewood, the maximum temperature value is reached and the gases emitted from the firewood decrease slowly along with the volume of the flames. When the firewood gas emission is complete, the flame goes out and the firewood turns to burning embers. - The fuel load should have the approximate weight recommended by the manufacturer for each model.
Page 6
Adjusting primary and secondary air inlets You have purchased an insert model that offers maximum efficiency and performance. Therefore, control of the primary air inlet, located in the ashtray, and the secondary air inlet, located on the left of the front of the appliance, are essential to achieve optimum combustion levels.
Secondary air regulation will provide greater control of combustion, slowing down combustion and making the most of every load of firewood. In order to avoid burns, always use the adjustment tool supplied with the appliance to adjust the secondary air inlet. Closed Open Cold hand...
MAINTENANCE To clean the glass, be careful to spray the cleaning product on a cloth and clean only the glass, without wetting the rest of the door. Window-cleaners and special products often contain chemicals that attack the paint and the ceramic fibre seals and cause oxidation of the metal parts. It is very important not to wet the woodburner with window-cleaner, water or special cleaning products.
Page 9
Removing the double baffle Cross-section view of the insert Remove the vermiculite Steel deflector deflector Vermiculite deflector Bracket (x2) Remove the Remove the two brackets steel deflector Invert the assembly process Note: the c-60 Plus model does not include brackets.
Page 10
If there is no draught, you can adjust the steel deflector to evacuate fumes. Note: opening the deflector will reduce the performance of the insert. Baffle C-70 Plus, C-80 Plus, C-100 Plus Pre-cut for adjustment Lift the tab for the...
Page 11
Carbel C-80 Plus Double-sided 120 kg 74.70% 10.7 kW 0.27% 2.5 kg 4.2 kg 0.75 h 12 Pa 349 ºC Carbel C-100 Plus Double-sided 150 kg 74.70% 12.8 kW 0.27% 3 kg 5.5 kg 0.75 h 12 Pa 349 ºC Carbel H-69 S 75 kg 9.1 kW...
Page 13
CARBEL, S.L. Cocinas C/ Ciudad de Cartagena, 22 46988 Polígono Industrial Fuente de Jarro (Paterna) Valencia Tel. 96 1340716 Fax: 96 1340449 E-mail: carbel@carbel.net...
For the warranty to take effect, the manufacturer must be sent a copy of this certificate and a copy of the customer invoice. DEALER’S SIGNATURE AND STAMP CUSTOMER’S COPY Cocinas Carbel, S.L C/ Ciudad de Cartagena, 22 Polígono Industrial Fuente del Jarro...
Need help?
Do you have a question about the C-70 Plus and is the answer not in the manual?
Questions and answers