Connecting The Bdi2000 To Power Supply - Abatron BDI2000 User Manual

NDI
bdi
JTAG debug interface for EDGE Debugger, BDI2000 (PPC6xx/7xx/82xx/83xx)

2.2 Connecting the BDI2000 to Power Supply

The BDI2000 needs to be supplied with 5 Volts (max. 1A) via the POWER connector. The available
power supply from Abatron (option) or the enclosed power cable can be directly connected. In order
to ensure reliable operation of the BDI2000, keep the power supply cable as short as possible.
For error-free operation, the power supply to the BDI2000 must be between 4.75V and 5.25V DC.
The maximal tolerable supply voltage is 5.25 VDC. Any higher voltage or a wrong polarity
might destroy the electronics.
Rev. B Version
The green LED «BDI» marked light up when 5V power is connected to the BDI2000
Please switch on the system in the following sequence:
• 1 --> external power supply
• 2 --> target system
© Copyright 1992-2007 by ABATRON AG
GND 3
4
RS232 POWER
BDI TRGT MODE TARGET A
!
1 Vcc
2
LI TX RX 10 BASE-T
TARGET B
User Manual 7
POWER
Connector
1 - Vcc (+5V)
2 - VccTGT
3 - GROUND
4 - NOT USED
V 1.01