Advertisement
INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN, READ THE FOLLOWING
INSTRUCTIONS
COMPLETELY
AND
CAREFULLY. THEY WILL SIMPLIFY
THE INSTALLATION.
1.
After removing the shipping carton, be sure to remove
all protective packaging materials such as tape and
shipping pads. Waxy residue from protective shipping
material may be removed from compactor with a mild
solution of liquid household cleaner and water.
2.
Your compactor is designed for recessed installation.
A six (6) inch clearance from the right edge of the
drawer front is desirable for added convenience in bag
removal. Also allow twenty-three (23) inches in front of
the appliance for drawer removal. See Figure 2.
COYPAClOR
\
L!Gl
IId
u
FIGURE 2
3. The compactor's overall dimensions are: Height 34-
1/1 6" (min.), Depth 24", Width 15". Select a cabinet
opening to fit. See Figure 3.
f
34-l/16"
I
fil
I(
-l-,5q24-
FIGURE 3
4.
Remove drawer as shown:
a.
Grip handle and raise front of drawer until it
clears stops. See Figure 4.
b.
Grasp side ridges of the drawer and lift drawer
out. See Figure 5.
FIGURE 4
-FIGURE 5
5.
Remove any materials that are shipped in the drawer.
6.
Lay two carton corner posts or other protective
material (such as a throw rug) on the floor, then lay
the unit on either of its sides on the corner posts.
The corner posts will protect the finish of the
compactor and the floor. See Figure 6. NOTE: Do not
truck or handle bv console.
HGURE 6
Remove the cardboard shipping pad located on the
bottom. See Figure 6. Stand compactor upright.
7. A grounded receptacle should be located 18" (min.)
from the floor and in the center of the opening. See
Figure Z
- -
1
16" (MN I
- -
[
r
FIGURE 7
8.
Before moving the compactor into position, measure
the cabinet opening as shown in Figure 8.
To
determine if height adjustment is required, see steps
9 and 10 below.
Tr
,I
+~CA"'N~;
OPENING
DIlLi
-
1
'
1
FlGURE 8
9. The rear wheels of your compactor are preset for a
minimum
cabinet opening
of 34-l/8"
to 34-114"
(position A). To adjust for higher openings, tilt the
compactor to one side and support with a corner post
or a screwdriver handle.
CAUTION: Use care so that the compactor does
not drop on your hand.
10.
To adjust the height, remove screw from position "A"
in Figure 9.
Move the rear wheel and screw to
position "B or C":
34-l/4"
to 34-l/2"
use position "B"
34-l/2"
to 343/4"
use position "C"
FIGURE 9
Repeat for other rear wheel.
7
Advertisement
